Related Experiment Video
Updated: Jun 16, 2025

Expression of Cementitious Pore Solution and the Analysis of Its Chemical Composition and Resistivity Using X-ray Fluorescence
Published on: September 23, 2018
Early Hydration Characteristics and Kinetics Model of Ordinary Portland Cement-Calcium Sulfoaluminate Cement
Jincai Chen1, Bo Xie1, Zhongyu Lu1
1School of Civil and Transportation Engineering, Guangdong University of Technology, Guangzhou 510006, China.
Abstract:
This study investigates the early hydration characteristics and kinetics of ordinary Portland cement (OPC) and calcium sulfoaluminate cement (CSA) composite pastes. The hydration mechanisms of OPC-CSA systems with different proportions are analyzed through zonal analysis and the Krstulović-Dabić method. The experimental results show that in OPC-dominated systems, an appropriate amount of CSA promotes the rapid hydration of ye'elimite and optimizes the cumulative hydration heat and pore structure. However, excessive CSA inhibits hydration due to alkalinity imbalance. In CSA-dominated systems, 10% OPC increases the alkalinity, promoting ye'elimite to hydrate into ettringite. Higher OPC content hinders the hydration process due to ion concentration imbalance. The kinetics model indicates that CSA accelerates the interfacial reaction and diffusion in the OPC system, while OPC reduces the overall hydration rate of the CSA system. Microscopic analysis confirms that the composite system improves the pore structure through mineral interaction. In the OPC-dominated area, the pore structure is mainly composed of small and dense pores. In the CSA-dominated area, the characteristics of large pores are affected by the expansion properties of CSA and hydration heat. This study constructs a coupling mechanism of alkalinity regulation and crystal nucleus generation, providing a theoretical basis for the design of high-performance composite cement materials.
More Related Videos
Related Concept Videos
Hydration of Cement
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...
Types of Cement II
Setting Time of Cement
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

