Error in Results Section
These videos have been matched automatically. Contact us if they are not relevant.
These videos have been matched automatically. Contact us if they are not relevant.
These videos have been matched automatically. Contact us if they are not relevant.
These videos have been matched automatically. Contact us if they are not relevant.
Related Concept Videos
2.2K
In the case of systematic errors, the sources can be identified, and the errors can be subsequently minimized by addressing these sources. According to the source, systematic errors can be divided into sampling, instrumental, methodological, and personal errors.
Sampling errors originate from improper sampling methods or the wrong sample population. These errors can be minimized by refining the sampling strategy. Defective instruments or faulty calibrations are the sources of instrumental...
4.5K
When performing a hypothesis test, there are four possible outcomes depending on the actual truth (or falseness) of the null hypothesis and the decision to reject or not.
The decision is not to reject null hypothesis when it is true (correct decision).
The decision is to reject the null hypothesis when it is true (incorrect decision known as a Type I error).
The decision is not to reject the null hypothesis when, in fact, it is false (incorrect decision known as a Type II error).
The...
280
Hypothesis testing is a fundamental statistical tool that begins with the assumption that the null hypothesis H0 is true. During this process, two types of errors can occur: Type I and Type II. A Type I error refers to the incorrect rejection of a true null hypothesis, while a Type II error involves the failure to reject a false null hypothesis.
In hypothesis testing, the probability of making a Type I error, denoted as α, is commonly set at 0.05. This significance level indicates a 5%...
1.9K
The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
12.4K
Scientists always try their best to record measurements with the utmost accuracy and precision. However, sometimes errors do occur. These errors can be random or systematic. Random errors are observed due to the inconsistency or fluctuation in the measurement process, or variations in the quantity itself that is being measured. Such errors fluctuate from being greater than or less than the true value in repeated measurements. Consider a scientist measuring the length of an earthworm using a...
774
When magnetic nuclei in a sample achieve resonance and undergo relaxation, the signal detected in NMR is an approximately exponential free induction decay. Fourier transform of an exponential decay yields a Lorentzian peak in the frequency domain. Lorentzian peaks in an NMR spectrum are defined by their amplitude, full width at half maximum, and position, where the peak width is governed by the spin-spin relaxation time alone. In real experiments, however, the applied magnetic field is rendered...