Non-solvents as physical blowing agents in printable silicone foams

Silicone foams were produced by dispersing an incompatible liquid phase (i.e. a non-solvent) into an uncured, liquid silicone. The formulation and processing parameters were varied to see the effect on porosity and pore morphology. Specifically, two fluorosilanes were added to stabilize the inclusion of fluorinated solvents as blowing agents. As the floruosilane content increased, the void content increased up to about 44 vol. % when the fluorosilane comprised 18 wt. % of the initial formulation. Fumed silica that was treated with a fluorinated silane was also used to try to stabilize the dispersed liquid. While the fumed silica content did not have a strong effect on the total void content, the morphology changed when silica content changed. Various fluorinated solvents with distinct chemical structures were used as the non-solvent and then removed after curing of the silicone. The interaction of the internal non-solvent phase and the silicone phase was expected to influence the porosity. These insights highlight how the manipulation of formulation and processing parameters, focusing on the inclusion of fluorosilanes and fluorinated solvents, contributes to the understanding of how incompatible liquid phases interact with silicone matrices to control porosity and pore morphology. Additionally, these interactions also influenced processability, leading to formulations that could be printed. Higher content of non-solvent inclusions could increase the yield stress and storage modulus of an uncured formulation, leading to the ability to tune intrastrand porosity while a 3D printed architecture could be modified to introduce porosity between the strands. In addition to fluorinated solvents, we also considered non-fluorinated solvents since these may be more industrially relevant in the future. Overall, this approach provides an alternative route to producing porous foams that can be 3D printed, which could be useful for applications like cushioning and protective gear.