Related Experiment Video
Updated: Sep 17, 2025

Real-Time DC-dynamic Biasing Method for Switching Time Improvement in Severely Underdamped Fringing-field Electrostatic MEMS Actuators
Published on: August 15, 2014
Practical design of variable fractional-order capacitors with a single tuning feature using field effect transistors
Roman Sotner1,2, Chloe Black3, Jan Jerabek4
1Faculty of Electrical Engineering and Communication, Brno University of Technology, Technicka 3082/12, Brno, 616 00, Czech Republic. sotner@vut.cz.
Abstract:
This paper presents two discrete circuit solutions for realizing passive, electronically adjustable constant-phase elements, specifically half-order capacitors with a -45° phase shift. Fractional-order capacitors with electronically adjustable pseudocapacitance are especially useful for designing tunable filters and oscillators. The ability to adjust pseudocapacitance electronically and continuously is a major improvement over traditional passive solutions. Their pseudocapacitance can be controlled by a DC voltage, allowing key parameters like the cut-off or oscillation frequency to be tuned. Two presented design approaches differ in accuracy, tuning range, and signal-handling capability. Both solutions maintain a constant phase over one frequency decade, with a phase ripple within ± 2°. The tuning range spans from hundreds of Hz to several MHz. Presented solutions allow pseudocapacitance tuning in range of hundreds of nano F/sec0.5 (with varicaps) and tens of micro F/sec0.5 (with MOSFETs). The MOS-based circuit offers a tuning ratio of 7 but shows a 19% deviation between simulation and measurement. It also suffers from notable nonlinearity, with undistorted operation limited to signal levels up to 20 mV peak-to-peak. The varicap-based solution achieves a tuning ratio of 5, with high accuracy (up to 6% error), and handles input signals in the hundreds of mV with acceptable distortion. PSpice simulations and laboratory measurements confirm the performance of both designs.
Related Concept Videos
Design Example: Capacitance Multiplier Circuit
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Capacitors
When a voltage source is connected to a capacitor, positive and negative charges accumulate on the opposite plates. This accumulation generates a potential difference that equals the product of the...
Capacitor With A Dielectric
Dielectrics are non-conducting materials with no free or loosely bound electrons. When a dielectric is...
RC Circuits: Charging A Capacitor
When the switch is moved to connect the battery, the circuit reduces to a simple...
Series and Parallel Capacitors
First, consider capacitors connected in series to a battery. In this configuration, the plate connected to the battery's positive terminal develops a positive charge, while the plate attached to the negative terminal becomes negatively charged. An equal magnitude of charge is induced on the...
Design Example: Underdamped Parallel RLC Circuit
Starting with a fixed...

