Related Experiment Video

Updated: Jul 26, 2026

An Intramedullary Locking Nail for Standardized Fixation of Femur Osteotomies to Analyze Normal and Defective Bone Healing in Mice
07:41

An Intramedullary Locking Nail for Standardized Fixation of Femur Osteotomies to Analyze Normal and Defective Bone Healing in Mice

Published on: November 13, 2016

13.5K

Outcomes of Fibular Nailing: Experience from a Single Center

Chun Liang Lau1, Kwong-Lee Wan1, Kit Chuen Wong1

  • 1Orthopaedics/Foot and Ankle Surgery, Hospital Seberang Jaya, Penang, MYS.

Cureus
|July 7, 2025
PubMed

Keywords:
fibula fracturefibular nailfoot and ankle fracturerodweber

More Related Videos

Treatment of Ankle Osteoarthritis with Total Ankle Replacement Through a Lateral Transfibular Approach09:01

Treatment of Ankle Osteoarthritis with Total Ankle Replacement Through a Lateral Transfibular Approach

Published on: January 24, 2018

11.9K
Treatment with Locking Intramedullary Nailing for Intertrochanteric Fracture of the Femur Utilizing a New Awl with a Distal Positioner04:41

Treatment with Locking Intramedullary Nailing for Intertrochanteric Fracture of the Femur Utilizing a New Awl with a Distal Positioner

Published on: June 6, 2025

244

Related Concept Videos

Longitudinal Research02:20

Longitudinal Research

Sometimes we want to see how people change over time, as in studies of human development and lifespan. When we test the same group of individuals repeatedly over an extended period of time, we are conducting longitudinal research. Longitudinal research is a research design in which data-gathering is administered repeatedly over an extended period of time. For example, we may survey a group of individuals about their dietary habits at age 20, retest them a decade later at age 30, and then again...
Significance of Center of Mass01:12

Significance of Center of Mass

The center of mass of an object is defined as the mass-weighted average position of all the particles that comprise the object. The significance of the center of mass of an object can be seen by looking at its dynamics. The time derivative of the center of mass gives its velocity, assuming that the object's mass remains constant over time. Furthermore, the total linear momentum of an object can be seen as the linear momentum of a single particle of the object's total mass moving with the...
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...
Circular Shaft - Stresses in Linear Range01:13

Circular Shaft - Stresses in Linear Range

Consider a scenario where a circular shaft is subject to torque that remains within the boundaries of Hooke's Law, avoiding any permanent deformation. So, the formula for shearing strain is revisited. This formula is multiplied by the modulus of rigidity, and then Hooke's Law for the shearing stress and strain is applied. As a result, the equation for shearing stress in a shaft can be derived.
Stress Concentrations in Circular Shafts01:18

Stress Concentrations in Circular Shafts

Consider the elastic torsion formula, which applies to a circular shaft with a consistent cross-section. This formula assumes that the shaft's ends are loaded with rigid plates firmly attached. However, in many cases, torques are applied to the shaft through mechanisms like flange couplings or gears, which are connected by keys inserted into keyways. This application method modifies the stress distribution near the point of torque application, causing it to deviate from the distributions...