Multi-dimensional water quality indicators forecasting from IoT sensors: A tensor decomposition and multi-head

Li Bo1, Lv Junrui2, Luo Xuegang2

  • 1School of Information and Engineering, Sichuan Tourism University, Chengdu, China.

Plos One
|July 11, 2025
PubMed

Related Concept Videos

Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
189
Multi-input and Multi-variable systems01:22

Multi-input and Multi-variable systems

Cruise control systems in cars are designed as multi-input systems to maintain a driver's desired speed while compensating for external disturbances such as changes in terrain. The block diagram for a cruise control system typically includes two main inputs: the desired speed set by the driver and any external disturbances, such as the incline of the road. By adjusting the engine throttle, the system maintains the vehicle's speed as close to the desired value as possible.
In the absence...
150
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
194
Time-Series Graph00:54

Time-Series Graph

A time-series graph is a line graph with repeated measurements taken at successive intervals of time. It is also called a time series chart. To construct a time-series graph, one must look at both pieces of a paired data set. The horizontal axis is used to plot the time increments, and the vertical axis is used to plot the values of the variable that one is measuring. By using the axes in this way, each point on the graph will correspond to time and a measured quantity. The points on the graph...
4.5K