Assessing Flight Angle and Rotor Speed Effects on Drying Efficiency and Power Consumption of the Centrifugal Dryer of...

This study used the Discrete Element Method (DEM) coupled with the Moving Particle Semi-implicit (MPS) method to investigate the process of drying in the centrifugal unit of a pelletizing system in polymer processing. The effects of various flight angles (10°, 45°, and 70°) and rotor speeds (1280, 1600, and 1920 rpm) on drying efficiency, polymer pellet transport, polymer pellet accumulation, and power consumption were examined. The results showed that the flight angle significantly influenced drying performance. At 1600 rpm, the 10° flight angle configuration required the least power (10.94 kW) but resulted in inefficient water separation, which led to an increase in water droplets (i.e., higher moisture content) in the upper part of the centrifugal unit and near the outlet. With a 70° flight angle, water removal was most effective, but polymer pellet transport efficiency was lower due to centrifugal forces becoming dominant. A 45° flight angle provided the best balance between drying efficiency and power consumption, requiring 16.42 kW while achieving the most efficient polymer pellet transport. Rotor speed also played a crucial role: lower speeds enhanced water removal and reduced power demand but limited throughput, whereas higher speeds facilitated centrifugal separation at the cost of increased power consumption. The optimal combination of the rotor speed and flight angle was found to be 45° at 1280 rpm, which offered an effective trade-off between drying performance and power efficiency.