Salidroside improves bovine embryo quality by mitigating oxidative stress and regulating mitochondrial lipid

Li-Ying Liu1, Xian-Feng Yu1, Zhi-Chao Chi1

  • 1Jilin Provincial Key Laboratory of Animal Model, College of Animal Science, Jilin University, Changchun, 130062, China.

Theriogenology
|July 13, 2025
PubMed

Related Concept Videos

Fertilization01:38

Fertilization

During fertilization, an egg and sperm cell fuse to create a new diploid structure. In humans, the process occurs once the egg has been released from the ovary, and travels into the fallopian tubes. The process requires several key steps: 1) sperm present in the genital tract must locate the egg; 2) once there, sperm need to release enzymes to help them burrow through the protective zona pellucida of the egg; and 3) the membranes of a single sperm cell and egg must fuse, with the sperm...
Cloning of Dolly the Sheep01:08

Cloning of Dolly the Sheep

The first successfully cloned mammal was Dolly, a sheep, born on 5th July 1996 at Roslin Institute, Scotland. The cloned sheep was named after the American singer Dolly Parton. Dolly lived for seven years and died of respiratory complications, which is speculated to be due to the actual age of her DNA. Because the DNA in cloned cells belongs to an older individual,  the cloned individual’s life expectancy may be affected. Indeed, analysis of Dolly’s DNA revealed shorter telomeres than other...
Ovarian Cycle01:27

Ovarian Cycle

The menstrual cycle includes a critical component known as the ovarian cycle, which undergoes two main phases each month—the follicular phase and the luteal phase. The follicular phase is variable and averaging around 14 days. Ovulation, triggered by a surge in luteinizing hormone (LH), marks the transition between the two phases. The second phase, the luteal phase, is relatively consistent, lasting approximately 14 days, and is marked by the activity of the corpus luteum. While a cycle length...
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
Bioreactor Controls-III01:22

Bioreactor Controls-III

Strain improvement is a foundational strategy in industrial microbiology aimed at maximizing microbial productivity, particularly because natural isolates typically yield commercially valuable products in very low concentrations. Although optimizing the culture medium and environmental conditions can improve yields, these adjustments are inherently limited by the organism’s genetic potential. As a result, the focus shifts toward genetic modifications to enhance biosynthetic capacity. The...
Development of the Oral Microbiota01:28

Development of the Oral Microbiota

The establishment of the oral microbiome begins before birth, challenging the long-held belief that the fetal oral cavity is sterile. The presence of oral microbes such as Streptococcus and Fusobacterium in amniotic fluid suggests that microbial exposure may occur in utero, potentially through translocation from the maternal oral or gastrointestinal tract. This early colonization primes the neonatal immune system and sets the stage for subsequent microbial succession. Maternal health,...