[Study on the construction of a novel dentin remineralization system based on carboxylated polyamidoamine synergistic...

Objective: To explore the effect of carboxylated polyamidoamine (PAMAM-COOH) in combination with magnesium ions on the remineralization ability of amorphous calcium phosphate (ACP) in inducing remineralization of dentin collagen fibers in a 50% ethanol solution. Methods: Forty-five intact third molars extracted for impaction reasons were obtained from the College & Hospital of Stomatology, Guangxi Medical University. Two types of demineralized dentin specimens were prepared: ①Fully demineralized dentin (n=30), specimens were immersed in 17% ethylenediaminetetraacetic acid (EDTA) (pH=7.4) at room temperature for 14 days with daily solution refreshment; ②Partially demineralized dentin (n=15), specimens were treated with 37% phosphoric acid gel (Ultra-Etch, Ultradent) for 15 seconds followed by thorough rinsing with deionized water. Three remineralization groups were established for demineralized dentin treatment: ①Control group, 50% ethanol solution; ②ACMP group, 50% ethanol solution containing amorphous magnesium calcium phosphate (ACMP); ③PAMAM-COOH/ACMP group, 50% ethanol solution incorporating carboxylated polyamidoamine dendrimer-modified ACMP (PAMAM-COOH/ACMP). The chemical composition of remineralization solutions was analyzed by Fourier-transform infrared spectrum (FTIR). The morphology and particle size distribution of nanoparticles were characterized using transmission electron microscope (TEM). The fully demineralized dentin specimens were treated with three different remineralization solutions (37 ℃ for 7 days) respectively. The mineralization of the dentin collagen fibers surface was observed using scanning electron microscope (SEM) and the distribution of minerals inside and outside the collagen fibers was examined by using TEM. The partially demineralized dentin specimens were treated with fluorescence-labeled remineralization solutions (37 ℃ for 7 days) respectively, followed by analysis using confocal laser scanning microscopy (CLSM) to quantitatively evaluate the penetration depth of the mineralization agents. Results: FTIR analysis confirmed the presence of characteristic absorption peaks corresponding to phosphate (PO₄^3-) groups, carbon-nitrogen bonds, and amide linkages in the PAMAM-COOH/ACMP nanocomposite. TEM observed that the PAMAM-COOH/ACMP nanoparticles exhibited an average particle size of (36.85±8.02) nm in an amorphous state. SEM observation indicates continuous mineral deposition on dentin collagen fibers in the PAMAM-COOH/ACMP group, while no mineral deposition in the control group and only minimal deposition in the ACMP group. TEM showed no mineral deposition inside or outside the collagen fibers in the control group, only external mineral deposition in the ACMP group, and high-density mineral deposition both inside and outside the fibers in the PAMAM-COOH/ACMP group. CLSM analysis revealed a statistically significant difference (P<0.05) in the depth of mineralized substances entering dentin tubules between ACMP group and PAMAM-COOH/ACMP group. Conclusions: The remineralization system of 50% ethanol solution incorporating PAMAM-COOH/ACMP successfully achieved the internal and external mineralization of demineralized dentin collagen fibers.