Related Experiment Video

Updated: Sep 11, 2025

A Simple Approach to Manipulate Dissolved Oxygen for Animal Behavior Observations
06:20

A Simple Approach to Manipulate Dissolved Oxygen for Animal Behavior Observations

Published on: June 28, 2016

9.4K

New shine on an old habit: a pilot study on a glow soap faucet system

Liana Kubas1, Abbie Swenson1, Signe Penn1

  • 1Department of Chemistry, Bethel University, St Paul, MN, USA.

The Journal of Hospital Infection
|August 13, 2025
PubMed

Keywords:
Bacteria removalFluorescent soapGlow soapHand hygieneHandwashVisual feedback

More Related Videos

Design and Development of a Model to Study the Effect of Supplemental Oxygen on the Cystic Fibrosis Airway Microbiome07:38

Design and Development of a Model to Study the Effect of Supplemental Oxygen on the Cystic Fibrosis Airway Microbiome

Published on: August 3, 2021

2.4K
A Cost-effective and Reliable Method to Predict Mechanical Stress in Single-use and Standard Pumps07:34

A Cost-effective and Reliable Method to Predict Mechanical Stress in Single-use and Standard Pumps

Published on: August 5, 2015

9.6K

Related Concept Videos

Handwashing III: During the Procedure and Post-Procedure Steps01:15

Handwashing III: During the Procedure and Post-Procedure Steps

To wash hands properly, follow these steps:
1.7K
Handwashing II: Pre-procedure and Initial Procedure Steps01:19

Handwashing II: Pre-procedure and Initial Procedure Steps

The pre-procedure steps of handwashing include removing jewelry and rolling up sleeves. However, many organizations allow staff to wear wedding rings.
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury.  The nails must be short and clean, without nail...
1.1K
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
192
Design Example: Designing a Residential Plumbing System01:25

Design Example: Designing a Residential Plumbing System

The design of residential plumbing systems requires carefully evaluating water demand, flow rates, and pressure dynamics to ensure both efficiency and reliability. The nature of water flow within pipes is defined by its Reynolds number, which classifies flow as either laminar (smooth) or turbulent.
790
Handwashing I: Introduction and Types of Equipment01:18

Handwashing I: Introduction and Types of Equipment

Handwashing is hand hygiene with plain or antimicrobial soap and water to physically remove dirt, organic material, and microorganisms. However, it may not kill all microorganisms. The handwashing procedure requires a hand wash basin, liquid soap, paper towels, a domestic waste bin, and disposable nail cleaner as optional equipment.
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
4.5K