Thermal Treatment Prevents Effects of Downward Loads on the Screw-In Force Generation and Canal-Centering Ability of...

This study aimed to examine how downward load applied during instrumentation affects the stress generation and shaping properties in thermally treated and non-treated NiTi rotary instruments. ProTaper Universal (PTU; non-thermally treated) and ProTaper Gold (PTG; thermally treated) were used to prepare J-shaped canals in resin blocks. Load-controlled automated instrumentation and torque/force sensing devices were employed with preset downward loads of 1, 2, or 3 N (n = 10 each). The torque/force, instrumentation time, and canal-centering ratio were measured and analyzed using two-way or one-way analysis of variance with Tukey's test (α = 0.05). In the PTU-1N group, instrumentation was not completed because a ledge was formed in all canals. The PTU-3N group showed significantly greater upward force (screw-in force) and clockwise torque, along with a significantly smaller canal-centering ratio (less deviation) at the apical 0 mm level, than the PTU-2N group (p < 0.05). The downward load did not influence the instrumentation time (p > 0.05). In the PTG groups, these effects of downward load on the force generation and canal-centering ratio were not significant (p > 0.05). In the non-thermally treated PTU instruments, greater downward loads enhanced screw-in force while decreasing apical canal deviation; however, these effects were abolished in the thermally treated PTG instruments. This study highlights the importance of adapting the instrumentation technique with instrument characteristics: thermally treated flexible instruments facilitate smoother use, while stiffer, non-thermally treated ones may require precise control of downward loads.