Laser Surface Hardening of Carburized Steels: A Review of Process Parameters and Application in Gear Manufacturing

This article provides a comprehensive overview of recent studies concerning laser heat treatment (LHT) of structural and tool steels, with particular attention to the 21NiCrMo2 steel used for carburized gear wheels. Analysis includes the influence of critical laser processing conditions-including power output, motion speed, spot size, and focusing distance-on surface microhardness, hardening depth, and microstructure development. The findings indicate that the energy density is the dominant factor that affects the outcomes of LHT. Optimal results, in the form of a high surface microhardness and a sufficient depth of hardening, were achieved within the energy density range of 80-130 J/mm², allowing for martensitic transformation while avoiding defects such as melting or cracking. At densities below 50 J/mm², incomplete hardening occurred with minimal microhardness improvement. On the contrary, densities exceeding 150-180 J/mm² caused surface overheating and degradation. For carburized 21NiCrMo2 steel, the most effective parameters included 450-1050 W laser power, 1.7-2.5 mm/s scanning speed, and 2.0-2.3 mm beam diameter. The review confirms that process control through energy-based parameters allows for reliable prediction and optimization of LHT for industrial applications, particularly in components exposed to cyclic loads.