Related Experiment Video
Updated: May 2, 2026

Real-time Monitoring of Ligand-receptor Interactions with Fluorescence Resonance Energy Transfer
Published on: August 20, 2012
Balance Center Characteristic for Ultrafine Spectroscopic Analysis Using Rhodamine 6G Fluorescence Sensing as a Case
Lubiao Wang1, Weiwei Zhang2, Linfang Wu1
1Key Laboratory for Optoelectronic Information Perception and Instrumentation of Jiangxi Province, Nanchang Hangkong University, Nanchang, 330063, China.
Abstract:
Although Rhodamine 6G (R6G) has previously been considered insensitive to pH and stress, with no established applications in sensing these specific parameters, this article presents a breakthrough by re-evaluating its potential as active materials for temperature, pH, and stress sensing. This breakthrough is achieved by employing "balance center" instead of peak maximum or mean wavelength for characterizing the spectral emission band. To verify the improvement, R6G/resin composite samples were prepared. Then the balance center among all the spectral characteristics ensured the most precise identification of the fluorescence band shifts caused by any environmental changes onto the samples. Sensitivities of the prototype sensors with balance center output were calibrated as 0.0653(3) nm/°C in the range of 20 ~ 60 °C, 0.339(8) nm/pH in the pH range of 5.71 ~ 9.44, and - 0.63(2) nm/MPa (equivalently 18 cm-1/MPa) in the stress range of 0.07 ~ 1.43 MPa, respectively. Corresponding resolutions of the sensing systems were determined as 0.15 °C, 0.18 pH, and 0.03 MPa. These example sensors can be utilized in cytobiology research, demonstrating the potential for extensive sensing applications with a wide range of other fluorescent dyes.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

