Equilibrium refers to a state where a rigid body is not subjected to any translational or rotational motion. This state is achieved when the force and couple acting on a rigid body equal zero. When the system of external forces results in a net effect equivalent to zero, the rigid body is considered to be in equilibrium.
Internal forces are not considered for conditions of equilibrium because they occur in equal and opposite pairs within the body, effectively canceling each other. As a result,...

Topographic maps represent the Earth's surface features using contour lines, which connect points of equal elevation to create a two-dimensional representation of three-dimensional terrain. Creating a topographic map requires a systematic approach.Begin by plotting a scaled grid and marking intersections corresponding to the survey's elevation data points. Assign elevation values at these intersections to build the base map. Next, determine contour levels using a consistent contour interval,...

When a flat plate is submerged in a fluid, the fluid exerts pressure on the plate. This pressure can lead to many different phenomena, including drag and buoyancy. To understand the behavior of the fluid over a flat plate of variable width, it is essential to analyze the distribution of the pressure exerted.
The pressure distribution on the plate can be calculated by determining the force that acts on a differential area strip of the plate. Thus, the magnitude of the force is equal to the...

In power systems, the entire setup is divided into protective zones to isolate faults and protect the rest of the network. These zones include generators, transformers, buses, transmission lines, distribution lines, and motors. Each zone can be visualized as a separate room in a house, with each room protected by its own circuit breaker.
Protective zones are defined by closed dashed lines, containing one or more components. A key characteristic of these zones is the strategic placement of...

When a body is submerged in water, it experiences fluid pressure acting normal on its surface and distributed over its area. For better design structures, it is crucial to determine the magnitude and location of the resultant force acting on the surface. In the case of a rectangular plate of constant width submerged in water, the pressure increases with depth, resulting in a linearly varying trapezoidal pressure distribution from the upper to the lower edge of the plate.
The resultant force...

Sometimes waves do not seem to move; rather, they just vibrate in place. Unmoving waves can be seen on the surface of a glass of milk kept in a refrigerator, which is one example of standing waves. Vibrations from the refrigerator motor create waves on the milk that oscillate up and down but do not seem to move across the surface. These waves are formed or created by the superposition of two or more identical moving waves in opposite directions. The waves move through each other, with their...