Related Experiment Video
Updated: Sep 9, 2025

Development of an Individual-Tree Basal Area Increment Model using a Linear Mixed-Effects Approach
Published on: July 3, 2020
Maximum crown width model of Larix olgensis plantation and its application
Wei Zhang1, Guan-Mou Chen1, Ling-Bo Dong1
1Ministry of Education Key Laboratory of Sustainable Forest Ecosystem Management, School of Forestry, Northeast Forestry University, Harbin 150040, China.
Abstract:
Based on the survey data of 55 permanent plots of Larix olgensis plantation in Maoershan Experimental Forest Farm of Northeast Forestry University, we divided the stand density index (SDI) of the plots into three grades by mean±standard deviation method, namely SDI Ⅰ∈(0, 695], SDI Ⅱ∈(695, 1027], and SDI Ⅲ∈(1027, ∞] trees·hm-2. Based on the Logistic equation, we constructed the maximum crown width prediction model of individual tree at three quantiles (0.90, 0.95, and 0.99) under different SDI grades by coupling dummy variables and quantile regression. We further used the crown projection area method to compile the stand management density number table under different SDI grades and quantified the influence of stand density on stand volume and carbon storage. The results showed that the maximum crown width models of individual tree with different SDI had significant differences, and that the maximum crown width of individual tree could be better simulated at 0.90 quantile. The independent sample test showed that compared with the Logistic basic model, the Radj2 of the single-tree dummy variable quantile maximum crown model could be significantly increased by 0.20, while the root mean square error was significantly reduced by 0.15 m. Based on the established single tree dummy variable quantile maximum crown width model and crown projection area method, we compiled the stand management density number table under different SDI grades. When the target diameter of cultivation was 30 cm, compared with SDI Ⅰ, stand volume and carbon storage were overestimated by 26.16 m3·hm-2 and 10.10 t C·hm-2, respectively, when SDI grades were not distinguished. Similarly, compared with SDIⅡ, these values were overestimated by 15.99 m3·hm-2 and 6.12 t C·hm-2. However, compared with SDIⅢ, they were significantly underestimated by 85.13 m3·hm-2 and 33.04 t C·hm-2. Our results indicated that ignoring the differences of SDI grades could overestimate the carbon sequestration capacity of low-density stands but underestimate the actual contribution of high-density stands. Therefore, implementing stand density regulation based on SDI grades is conducive to achieving precise quality improvement of L. olgensis plantations.
Related Concept Videos
Structural Properties and Dimensions of Lumber
The strength characteristics of...
Lumber
Initially, the surfaces of these lumber pieces are rough, and their dimensions may vary slightly from one end to...
Softwoods and Hardwoods
Wood Products
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...

