Related Experiment Video
Updated: Sep 9, 2025

Operation of the Collaborative Composite Manufacturing CCM System
Published on: October 1, 2019
Recovery strategy of fault distribution network considering collaborative optimization of recovery and repair
Naiwei Tu1, Yibo Shi1, Yuqiang Hao1
1Faculty of Electrical and Control Engineering, Liaoning Technical University, Huludao, China.
Abstract:
For the fault recovery and emergency repair after multiple faults in the distribution network, this paper proposes a fault distribution network recovery strategy considering the collaborative optimization of recovery and emergency repair. Initially, due to the difference and uncertainty between the system load demand and the distributed generation (DG) output, a bilayer dynamic fault recovery with phase type in time scale was constructed. The upper layer considers the recovery of the distribution network during faults, optimizing network reconfiguration schemes using DG outputs predicted by deep stochastic configuration network in conjunction with time-varying load demands. The lower considers the economic effect of the loss during repair and determines the optimal fault repair sequence. Furthermore, an enhanced Nutcracker Optimization algorithm to solve the bilayer model was proposed, determining the dynamic combination of the fault reconfiguration scheme and the repair sequence. Finally, to validate this strategy, this paper conducted simulations using the IEEE 33-node system. The experimental results under multiple strategies show the feasibility and effectiveness of this paper strategy, which ensures the effective recovery of fault nodes after power failure.
Related Concept Videos
Reclosers and Fuses
A comprehensive protection scheme for radial distribution...
Distribution Reliability and Automation
Distributed Loads: Problem Solving
Fast Decoupled and DC Powerflow
Zones of Protection
Protective zones are defined by closed dashed lines, containing one or more components. A key characteristic of these zones is the strategic placement of...
Radial System Protection
In a radial system with a fault downstream of the third breaker, ideally, only the third breaker will open, isolating the fault and interrupting the load connected beyond it. The second breaker has a longer delay setting,...

