Related Experiment Video
Updated: May 6, 2026

Integrated Field Lysimetry and Porewater Sampling for Evaluation of Chemical Mobility in Soils and Established Vegetation
Published on: July 4, 2014
Evaluation of Polymer-Based Dust Palliatives in Soil and Stormwater Runoff in an Arid Environment
Angela P Paul1, Erin Orozco-Whitaker2, Sareeha Shamsuddin3
1Nevada Water Science Center, US Geological Survey, Carson City, NV, USA. appaul@usgs.gov.
Abstract:
Dust palliatives are used to reduce fugitive dust in areas susceptible to erosion by wind and rain. In 2015, the Bureau of Land Management (BLM) temporarily approved the use of polymer-based dust palliatives during the construction and operation of a solar energy facility and, in 2019, on a mining access road in Clark County, Nevada. The areas treated with palliative are habitat to the desert tortoise. The desert tortoise consumes water opportunistically from puddles, saturated soils, or by the collection of precipitation on their carapaces. Since little is known about the toxicity of polymeric substances to the desert tortoise, the BLM is concerned with the exposure of the desert tortoise to palliative in stormwater runoff. The BLM collaborated with the US Geological Survey (USGS) to evaluate the transport of butyl acrylate vinyl acetate (BA-VA), the copolymer ingredient in the dust palliatives applied in the study, away from areas of application. BA-VA concentrations were measured in soils treated with palliative up to 90 days post-treatment, after which the copolymer became undetectable (< 0.55 mg/g). BA-VA concentrations in all stormwater samples within and outside treated areas were consistently below detection (< 0.20 mg/mL). Although stormwater and treated soils eroded from the solar facility application area were found to have BA-VA concentrations below detection (< 0.55 mg/g), it is likely that some BA-VA (parent or degradation product) was transported with suspended material. It is also likely that the amount of BA-VA transported away from areas of application was a small fraction of that applied.
More Related Videos
07:47Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
08:49Vegetated Treatment Systems for Removing Contaminants Associated with Surface Water Toxicity in Agriculture and Urban Runoff
Published on: May 15, 2017
Related Concept Videos
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Plasticizers
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
Microbial Bioremediation of Pesticides