Related Experiment Video

Updated: Jan 17, 2026

Oral Biofilm Formation on Different Materials for Dental Implants
11:19

Oral Biofilm Formation on Different Materials for Dental Implants

Published on: June 24, 2018

12.1K

Effect of Water Flow on Bond Strength of Zirconia to Tooth Structure

R V Monteiro, E Brown, J Itani

    Operative Dentistry
    |September 24, 2025
    PubMed

    More Related Videos

    Roughness Impact of Piezoelectric Dental Scaler on Two Distinct Flowable Composite Filling Materials05:30

    Roughness Impact of Piezoelectric Dental Scaler on Two Distinct Flowable Composite Filling Materials

    Published on: January 10, 2025

    1.1K
    Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material07:42

    Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material

    Published on: December 20, 2024

    764

    Related Concept Videos

    Bonding and Strength of Aggregate01:12

    Bonding and Strength of Aggregate

    The bond between aggregate particles and the cement matrix is significantly influenced by the shape and surface texture of the aggregates. High-strength concretes benefit from a rougher texture, which leads to stronger bonding due to greater adhesion. Angular aggregates with larger surface areas also enhance this bond. The bonding quality, however, is complex to assess as no universally accepted test exists. Good bonding is indicated when a crushed concrete specimen shows some aggregate...
    468
    Transition Zone01:28

    Transition Zone

    The transition zone in concrete is a critical area where aggregate meets cement paste, marked by a distinct porosity and weakness compared to the surrounding material. The adhesion around the aggregates is primarily due to Van Der Waals forces. The voids within this zone influence its robustness; initially, it is less durable than the surrounding bulk mortar due to larger voids. Initially, when concrete is compacted, a higher water-cement ratio near the aggregates leads to the formation of...
    346
    Introduction to Chemical Bonds01:01

    Introduction to Chemical Bonds

    Chemical Bonds
    The electrons of the outermost energy level determine the energetic stability of the atom and its tendency to form chemical bonds with other atoms. The innermost electron shell has a maximum capacity of two electrons, but the next two electron shells can each have a maximum of eight electrons. This is known as the octet rule, which states that, with the exception of the innermost shell, atoms are most stable energetically when they have eight electrons in their valence shell, the...
    10.9K
    Bond Polarity, Dipole Moment, and Percent Ionic Character02:48

    Bond Polarity, Dipole Moment, and Percent Ionic Character

    Bond Polarity
    35.0K
    Testing Water Quality01:14

    Testing Water Quality

    When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
    368
    Chemical Bonds02:40

    Chemical Bonds


    Atoms participate in a chemical bond formation to acquire a completed valence-shell electron configuration similar to that of the noble gas nearest to it in atomic number. Ionic, covalent, and metallic bonds are some of the important types of chemical bonds. Bond energy and bond length determine the strength of a chemical bond.
    Types of Chemical Bonds
    An ionic bond is formed due to electrostatic attraction between cations and anions. Often, the ions are formed by the transfer of electrons...
    21.0K