Related Experiment Video
Updated: Jan 16, 2026

Proof-of-Concept for Gas-Entrapping Membranes Derived from Water-Loving SiO2/Si/SiO2 Wafers for Green Desalination
Published on: March 1, 2020
Zero Liquid Discharge of High-Salinity Produced Water via Integrated Membrane Distillation and Crystallization:
Gabriela Torres Fernandez1, Zongjie He2, Jeremiah Kessie3
1Department of Civil and Environmental Engineering, New Mexico Institute of Mining and Technology, Socorro, NM 87801, USA.
Abstract:
Direct Contact Membrane Distillation-Crystallization (DCMD-Cr) is a synergistic technology for zero liquid discharge (ZLD) and resource recovery from high-salinity brines. In this study, DCMD-Cr was integrated to desalinate real oilfield-produced water (PW) with an initial salinity of 156,700 mg/L. The PW was concentrated to its saturation point of 28 wt.% via DCMD, and the integrated crystallization increased the overall water recovery from 42.0% to 98.9%, with a decline in water flux and salt rejection, mainly due to vapor pressure lowering and scaling. The precipitated salts in the crystallization unit were recovered and identified using different techniques. The results indicated that 91% of the crystals are sodium chloride, and less than 5% are calcium sulfate. A techno-economic analysis (TEA) was performed to evaluate the economic feasibility of the integrated DCMD-Cr process with a 500,000 gallons per day (GDP) capacity. The results showed that the crystallization operating cost was dominant at USD 0.50 per barrel, while the capital cost was only USD 0.04 per barrel. The economic viability can be enhanced by recovering value-added byproducts and using renewable or waste heat, which can reduce the total cost to USD 0.50 per barrel.

