Related Experiment Video
Updated: Jan 16, 2026
Treatment of Facial Deformities using 3D Planning and Printing of Patient-Specific Implants
Published on: May 23, 2020
Sella turcica bridging and skeletal sagittal patterns in patients with third molar agenesis: A retrospective
Maria Francesca Sfondrini1, Maurizio Pascadopoli1, Enrico Sangalli1
1Unit of Orthodontics and Pediatric Dentistry, Section of Dentistry, Department of Clinical, Surgical, Diagnostic and Pediatric Sciences, Pavia, Italy.
Objectives:
To investigate the associations between sella turcica bridging (STB) and skeletal malocclusion patterns in orthodontic patients with third molar agenesis (TMA).
Methods:
Panoramic radiographs were taken from patients aged 8-18 years to identify TMA. All the patients were included between March 2023 and June 2023. Lateral cephalometric radiographs were obtained from both patients with TMA (agenesis group, AG) and those without TMA (control group, CG). Cephalometric measurements between the two groups were compared using the Mann-Whitney U test. The analysis of the sella turcica was carried out on lateral cephalometric radiographs based on Leonardi's classification. Linear regressions were performed between bridging, agenesis, cephalometric measurements, sex and age. Significance was set at P<0.05.
Results:
Four hundred patients were included in the study, 200 for the AG group and 200 for the CG. A statistically significant influence of agenesis on the sella depth measurement, which was on average higher in the AG compared to the CG, was found, particularly in cases of mandibular agenesis. Both ANB and A0B0 were significantly lower in the AG compared to the CG (P<0.05), especially in the mandibular agenesis subgroup. Although the results are statistically significant for the A0B0 and SNB values, they were not clinically relevant. The intermaxillary angle is generally reduced in AG, indicating a greater tendency towards a hypodivergent skeletal pattern. The values of the joint angles, the total gonial angle, and the upper and lower gonial angles are slightly increased on average in AG compared to CG. The percentage ratio between posterior and anterior facial height is higher in AG compared to CG. The most important finding is that the mandibular body length is significantly shorter in AG.
Conclusions:
No significant association was found between TMA and the skeletal parameters of the sella turcica. A possible association was found between TMA and skeletal malocclusions, particularly Class III malocclusions.
Related Concept Videos
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...