Related Experiment Video
Updated: Jul 30, 2026
Oral Biofilm Formation on Different Materials for Dental Implants
Published on: June 24, 2018
Dental Implant Osseointegration Following Mandibular Augmentation Using 3D Printed Hydroxyapatite Blocks.
Simon Systermans1,2, Christophe Ronsmans2,3, Grégory Nolens4,5
1Department of Plastic and Maxillofacial Surgery, CHU Liège, Liège, Belgium.
Objective:
To evaluate the use and osseointegration of dental implants in combination with 3D-printed hydroxyapatite (3DHA) blocks featuring gyroid porosity for large mandibular bone augmentation.
Methods:
Mandibular lateral bone augmentation with gyroid-3DHA blocks was performed bilaterally on four female Göttingen minipigs. After 8 or 12 weeks of healing, a dental implant was placed into each 3DHA block. Following an additional 12-week healing period, the augmented sites (including 3DHA blocks and dental implants) were harvested for histological and histomorphometric analysis, assessing new bone formation, 3DHA integration, total bone gain, and bone-to-implant contact (BIC).
Results:
Gyroid-3DHA blocks were easily fixated with screws. Dental implants were placed through the 3DHA blocks with a standard drilling procedure, and good primary stability was achieved. 3DHA blocks demonstrated good osseointegration with 39.17% of new bone and a significant bone gain of 4.73 mm on average. Dental implants showed comparable BIC within the 3DHA and into the native bone (42.79% vs. 34.17%). No significant difference was found between the healing periods.
Conclusion:
This is the first study to evaluate a 3D-printed bone substitute in combination with a dental implant in an animal study. Gyroid-3DHA blocks and dental implants demonstrated good osseointegration, and the bone augmentation was significant, making it a promising material for large and complex alveolar ridge augmentations.
