Microscopic features of the effect of vehicle overacceleration on traffic flow

Boris S Kerner1, Sergey L Klenov2

  • 1University of Duisburg-Essen, Physics of Transport and Traffic, 47048 Duisburg, Germany.

Physical Review. E
|October 21, 2025
PubMed

Related Concept Videos

Introduction to Limits01:30

Introduction to Limits

A limit describes the value a function approaches as its input moves closer to a particular point. Even when a function is undefined at a specific value, limits allow us to analyze its behavior near that point. This concept is fundamental in calculus and essential for understanding continuity, derivatives, and integrals.Mathematically, a function f(x) has a limit L at x = a if its values L approach x as x gets arbitrarily close to a. This is written as:This notation expresses that the function...
187
Application of Rates of Change01:18

Application of Rates of Change

The movement of a car along a highway can be examined through key principles of calculus and kinematics. As the car travels, its position varies over time and can be represented mathematically as a function of time. Analyzing the rate of these changes enables the measurement of velocity and acceleration, fundamental aspects of motion analysis.Velocity describes how position changes over time. The average velocity during a specific time interval is calculated by dividing the change in position...
5
Instantaneous Acceleration01:16

Instantaneous Acceleration

Acceleration is in the direction of the change in velocity, but it is not always in the direction of motion. When an object slows down, its acceleration is opposite to the direction of its motion. Although commonly referred to as deceleration, this causes confusion in our analysis as deceleration is not a vector, and does not point to a specific direction with respect to a coordinate system. Therefore, the term deceleration is not used. For example, when a subway train slows down, it...
22.7K
Acceleration Vectors01:30

Acceleration Vectors

In everyday conversation, accelerating means speeding up. Acceleration is a vector in the same direction as the change in velocity, Δv, therefore the greater the acceleration, the greater the change in velocity over a given time. Since velocity is a vector, it can change in magnitude, direction, or both. Thus acceleration is a change in speed or direction, or both. For example, if a runner traveling at 10 km/h due east slows to a stop, reverses direction, and continues their run at 10 km/h...
21.6K
Impulse01:13

Impulse

According to Newton’s second law of motion, the rate of change of the momentum of an object is the net external force acting on it. The total change in momentum between two timepoints thus depends on both the external force acting on it and the time over which it acts. Describing this mathematically, the total change of an object’s motion is proportional to the force vector and the time over which it is applied. This product is called impulse.
Additionally, it can be shown that the...
21.3K
Velocity and Acceleration in Steady and Unsteady Flow01:11

Velocity and Acceleration in Steady and Unsteady Flow

In fluid mechanics, velocity and acceleration are key concepts for analyzing particle motion in both steady and unsteady flow. Consider a fluid particle moving along a pathline, where its velocity depends on its position and time. The particle's acceleration is obtained by differentiating the velocity with respect to time.
The acceleration can be generalized to any point in the flow, and expressed as components along three perpendicular directions, representing changes in velocity over...
382