Related Experiment Video

Updated: Jan 14, 2026

Soil Lysimeter Excavation for Coupled Hydrological, Geochemical, and Microbiological Investigations
10:30

Soil Lysimeter Excavation for Coupled Hydrological, Geochemical, and Microbiological Investigations

Published on: September 11, 2016

11.3K

Mapping residual water fluoride levels and geological patterns in a rural semi-arid area of Brazil

Marcos Alexandre Casimiro de Oliveira1,2, Alexandre Almeida Júnior3, Ilan Hudson Gomes de Santana3

  • 1Santa Maria University Center, Cajazeiras, 58900-000, Brazil. marcosalexandrec@gmail.com.

Scientific Reports
|October 23, 2025
PubMed

Keywords:
FluoridationFluorideGeological PhenomenaWater

More Related Videos

Measuring Carbon-based Contaminant Mineralization Using Combined CO2 Flux and Radiocarbon Analyses11:19

Measuring Carbon-based Contaminant Mineralization Using Combined CO2 Flux and Radiocarbon Analyses

Published on: October 21, 2016

12.3K
Measuring and Mapping Patterns of Soil Erosion and Deposition Related to Soil Carbonate Concentrations Under Agricultural Management08:09

Measuring and Mapping Patterns of Soil Erosion and Deposition Related to Soil Carbonate Concentrations Under Agricultural Management

Published on: September 12, 2017

12.3K

Related Concept Videos

Design Example: Analyzing Capacity Contours for Flood Risk Assessment01:17

Design Example: Analyzing Capacity Contours for Flood Risk Assessment

Flood risk assessment involves careful planning and analysis to ensure the safety of communities near water retention structures. Capacity contours are a vital tool in this process, as they illustrate the potential spread of water at specific levels in a given area. In the context of building a bund across a small valley, these contours play a critical role in evaluating the safety of nearby residential areas.In this example, the bund is intended to store stormwater in the valley. The engineers...
283
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
501
Porosity and Absorption of Aggregate01:20

Porosity and Absorption of Aggregate

Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
735
Water and Mineral Acquisition02:34

Water and Mineral Acquisition

Specialized tissues in plant roots have evolved to capture water, minerals, and some ions from the soil. Roots exhibit a variety of branching patterns that facilitate this process. The outermost root cells have specialized structures called root hairs that increase the root surface, thus increasing soil contact. Water can passively cross into roots, as the concentration of water in the soil is higher than that of the root tissue. Minerals, in contrast, are actively transported into root cells.
35.2K