Flux and Fouling Behavior of Graphene Oxide-Polyphenylsulfone Ultrafiltration Membranes Incorporating ZIF-67/ZIF-8...

Wider adoption of membrane technology is hindered by fouling and flux/rejection challenges. Recent practice in mitigating these is to incorporate hydrophilic and porous fillers. Herein the addition of hydrophilic graphene oxide (GO) in conjunction with porous mixed ZIFs (ZIF-67/ZIF-8) crystallites were used as inorganic fillers in the preparation of polyphenylenesulfone (PPSU) ultrafiltration (UF) membranes. The morphology of the resultant composite membranes was assessed using atomic force microscopy (AFM) and scanning electron microscopy (SEM) whilst surface hydrophilicity through water contact angle. The pure water flux (PWF) and membrane permeability were found to increase with increasing filler content. This was attributed to the combined hydrophilicity of GO and porous structure of the ZIF materials because of increasing alternative water pathways in the membrane matrix with increasing filler content. Furthermore, the increase in the ZIF component led to increasing bovine serum albumin (BSA) fouling resistance as demonstrated by increasing fouling recovery ratio (FRR). The dye rejection was due to a combination of electrostatic interaction between the fillers and the dyes as well as size exclusion. The chemical interactions between the ZIFs and the dyes resulted in slightly different rejection profiles for the smaller dyes, the cationic methylene blue being rejected less efficiently than the anionic methyl orange, potentially leading to their separation. The larger anionic dye, Congo red was rejected predominately through size exclusion.