Related Experiment Video
Updated: Jan 10, 2026

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Dynamic properties and microstructural characteristics of cement-coal gangue powder modified silty sand under
Chenkai Wang1,2, Lixia Wang3, Yunlong Zhang1
1School of Transportation Science and Engineering, Jilin Jianzhu University, Changchun, 130118, China.
Abstract:
The northeastern region of China, a typical seasonally frozen zone, contains silty sand subgrade that are subjected to long-term dynamic loads from vehicles and are highly susceptible to deformation and road distress, such as upheaval, under freeze-thaw (F-T) cycles. To enhance the dynamic properties and F-T resistance of silty sand subgrade, cement and coal gangue powder (CGP) were employed as modifiers. Through dynamic triaxial test and scanning electron microscopy (SEM) test, investigated the dynamic properties of modified silty sand with varying contents of cement and CGP, the dynamic behavior and micro-structural evolution under different F-T cycles, confining pressures, and loading cycles. As well as the correlation between micro-structural features and dynamic parameters was studied by grey relational analysis. The results revealed that the deviatoric stress amplitude of the modified silty sand increased significantly with higher cement content, while initially increased and then decreased with rising CGP content. Compared to silty sand, the modified soil maintained higher deviatoric stress amplitudes and dynamic elastic modulus across varying F-T cycles, loading cycles, and confining pressures. A significant correlation was identified between microstructural characteristics and dynamic parameters. F-T cycles caused considerable micro-structural degradation in silty sand, whereas the modified soil exhibited less structural variation. The incorporation of cement and CGP enhanced inter-particle cementation, filled pore spaces, and improved particle arrangement and pore distribution, thereby increasing structural stability and F-T resistance. Notably, the optimal ratio for cement-CGP modified silty sand was determined to be 2% cement and 8% CGP.
More Related Videos
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
09:46Protocol for Measuring the Thermal Properties of a Supercooled Synthetic Sand-water-gas-methane Hydrate Sample
Published on: March 21, 2016
Related Concept Videos
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of...
Frost Action on Concrete
This freeze-thaw cycle primarily causes surface scaling, where...
Unsoundness of Aggregate due to Volume Change
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...
Effects of Air-entrainment in Concrete
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...