Related Experiment Video
Updated: Jan 10, 2026

Mesocosm-Scale Constructed Wetland Design for Wastewater Treatment
Published on: May 2, 2025
Acid neutralization and metal mobilization in oil sands froth treatment tailings
Stuart R Ferry1, Mojtaba Abdolahnezhad1, Matthew B J Lindsay2
1Department of Geological Sciences, University of Saskatchewan, 114 Science Place, Saskatoon, SK, S7N 5E2, Canada.
Abstract:
Acid generation and metal(loid) release are growing considerations for oil sands mine closure in northern Alberta, Canada. Oxidative weathering of pyrite-bearing froth treatment tailings (FTT) has potential to promote acid generation and metal(loid) release. However, the acid-neutralization reactions and their influence on pore-water pH and metal(loid) mobility have not yet been reported. Laboratory column experiments examined acid-neutralization reactions and metal(loid) release for variably weathered (i.e., non-weathered, partially weathered, highly weathered) FTT samples collected from a commercial-scale beach deposit. Solvent-washed and non-solvent-washed splits of each sample were included to assess the influence of residual hydrocarbons. Acidic influent (i.e., 0.05 M H2SO4; pH ~ 1.5) was continuously pumped through each column, and effluent samples were collected for geochemical analysis over time. Effluent pH decreased from ~ 7.0 to 5.5 over the first 5 pore volumes for the non-weathered and partially weathered columns, while gradual pH decreases to ~ 4.5 were observed over the following 30 to 70 pore volumes. Subsequent decreases in effluent pH from ~ 4.5 to < 3.0 occurred over the next 2 to 5 pore volumes for these columns. In contrast, effluent pH consistently remained below 2.0 for the highly weathered columns. We attribute these effluent pH trends to the dissolution of Ca- and Mg-bearing carbonates (pH ~ 6.5 to 6), Fe-bearing carbonates (pH ~ 5.6 to 4.5), Al (oxy)hydroxides (pH ~ 4.5 to 4.0), and silicates (pH < ~ 2). Corresponding increases in effluent concentrations of Fe (< 1 to > 500 mg L- 1), Al (< 0.1 to > 10 mg L- 1), Si (< 0.1 to > 10 mg L- 1), and additional metal(loid)s (e.g., Ni, Zn, V, As) were observed with decreasing pH. Cumulative mass releases (e.g., Ca, Mg, Fe) were greatest for the non-weathered samples and solvent-washed splits. These results offer new insights into relationships between acid neutralization reactions and metal(loid) release that can inform FTT management and reclamation.
More Related Videos
11:14Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
09:23Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability
Published on: June 21, 2015
Related Concept Videos
Coagulation
Factors Affecting Solubility
Extraction: Advanced Methods
EDTA: Auxiliary Complexing Reagents
Acids, Bases and Neutralization Reactions
Acids, Bases and Neutralization Reactions