Related Experiment Video
Updated: Jan 9, 2026

The Effect of Anodization Parameters on the Aluminum Oxide Dielectric Layer of Thin-Film Transistors
Published on: May 24, 2020
Tunnel Thin-Film Transistors for Ultralow-Power and High-Performance Flexible Electronics
Dengbo Li1, Yuxin Cheng1, Wei Deng1
1State Key Laboratory of Bioinspired Interfacial Materials Science, Institute of Functional Nano & Soft Materials (FUNSOM), Soochow University, Suzhou, Jiangsu, 215123, China.
None:
Thin-film transistors (TFTs) are the cornerstone of large-area electronics, yet their capacity to enable low-power flexible technologies has been stifled by a fundamental constraint: the thermionic limit, which restricts the subthreshold swing (SS) to ≈60 mV dec-1 at room temperature. This intrinsic barrier has persisted as a critical bottleneck, impeding advancements in applications from wearable sensors to low-power flexible electronics. Here, flexible tunnel TFTs that harness quantum band-to-band tunneling are reported to transcend this fundamental limit. This tunnel TFTs, fabricated on an ultrathin (6 µm) flexible substrate, deliver subthermionic SS (28.8 mV dec-1) with a large intrinsic gain (≈104) under a mere 1 V operating voltage. By using a protective layer-assisted photolithography method, flexible tunnel TFT active-matrix arrays, flexible amplifiers, and various flexible logic circuits are successfully fabricated. The flexible tunnel TFT array can be bent multiple times with negligible degradation to a radius as small as 50 µm. The flexible amplifier shows a high gain of 1000 V/V, enabling the acquisition of high-quality electromyography signals with a signal-to-noise ratio of 77 dB. All the logic circuits demonstrate accurate Boolean output functionalities at picowatt-level power consumption, opening a new device concept for energy-efficient flexible electronics.

