Evaluation of aflatoxins and ochratoxin A levels in Indonesian nutmeg

Leni Febriyanti1,2, Budiawan Budiawan1, Harmoko Harmoko2

  • 1Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Indonesia, Depok, Indonesia.

Related Concept Videos

Ordinal Level of Measurement00:55

Ordinal Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
Data measured using an ordinal scale are similar to nominal scale data, but there is one major difference. The ordinal scale data can be ordered. An example of ordinal scale data is a list of the top five national parks in the...
Assessment of the Rectum and Anus01:25

Assessment of the Rectum and Anus

Evaluating the rectum and anus plays a crucial role in conducting a thorough physical examination of the gastrointestinal system. Although it may be uncomfortable and often embarrassing for the patient, it holds immense diagnostic value, particularly in detecting gastrointestinal diseases and abnormalities. This guide will explain how to perform this assessment using inspection and palpation methods.
Rectal Inspection
Begin by inspecting the perianal and anal areas for color, texture, rashes,...
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Non-destructive Tests for Concrete Strength01:12

Non-destructive Tests for Concrete Strength

The rebound hammer test, also known as the Schmidt hammer test, is a non-destructive technique for evaluating the hardness of concrete and, indirectly, the strength of concrete. It operates on the principle that the rebound of a spring-driven mass from a concrete surface correlates to the surface's hardness. The device comprises a mass within a tubular housing, a spring mechanism, and a plunger that strikes the concrete. Upon release, the energy imparted to the mass by the spring causes it to...
Kendall's Coefficient of Concordance01:20

Kendall's Coefficient of Concordance

Kendall's Coefficient of Concordance (W), also known as Kendall's W, is a non-parametric statistical measure used to assess the agreement or concordance between multiple raters or judges when they rank a set of items. It is often used when you have ordinal data (ranks) and you want to see if there is consistency or consensus among the raters. It is widely applied in research areas such as psychology, medicine, and social sciences, where multiple judges are asked to rank or rate subjects or...