Lateral Resistance of Modular CFS Shear Wall Connected with Rectangular Steel Tubes and Its Contribution to Frame...

Modular lightweight shear walls can not only facilitate easy installation, thereby improving construction efficiency, but also demonstrate potential to enhance the lateral stiffness when applied in frame structures. The aim of this paper is to investigate the effectiveness of a novel modular cold-formed steel (CFS) shear wall connected with rectangular steel tubes on improving the lateral performance of existing frame structures. Based on the test results of the lateral resistance of four full-scale specimens of modular CFS shear walls connected with rectangular steel tubes, the fine model and simplified model of test specimens were respectively established by the SAP2000v26.0.0 software. The performance indices of the yield load, yield displacement, peak load, peak displacement, and ductility factor were compared, and the maximum error of performance indices was satisfactory. The numerical results show that both the fine and simplified models can well simulate the deformation of walls under lateral cyclic loading, while the simplified models substantially simplify the calculation, which is more adaptable to the subsequent analysis of the multi-story building structure. Then, seismic response analyses of a frame with infilled modular walls and another frame without infilled modular walls were performed. The results indicate that, under the same seismic condition, the lateral displacements of the top floor of the six-story frame with infilled modular walls were reduced by 11-71%, and the maximum inter-story displacement angles were reduced by 15-67% compared to the frame without infilled walls. Therefore, it is demonstrated that the infilled modular CFS shear walls can significantly improve the lateral stiffness and the seismic performance of the steel frame structures.