Recognizing stressed chicken signs: A comparison using the Happy Chicken Tool and the Stressed Chicken Scale

Larissa Schlegel-Pape1, Robert Opitz2, Marko Henning3

  • 1Freie Universität Berlin, Faculty of Veterinary Medicine, Farm Animal Clinic - Division for Poultry, Königsweg 63, 14163 Berlin, Germany.

Poultry Science
|December 12, 2025
PubMed
Abstract

Related Concept Videos

Stress Response System01:21

Stress Response System

The stress response system, also known as the fight-or-flight response, is the body's automatic physiological reaction to perceived threats. Hans Selye introduced the concept of General Adaptation Syndrome (GAS) to describe the predictable pattern of changes that occur in response to stress. GAS consists of three sequential stages: alarm, resistance, and exhaustion. This model helps explain how chronic stress can contribute to health problems.
Alarm stage
In the alarm stage, the body's...
617
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
564
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
595
Principal Stresses01:24

Principal Stresses

The graphical depiction of normal and shearing stress equations is represented by a circle, demonstrating the interplay between these stresses under different angular conditions. The center of this circle C, located on the vertical axis, represents the average normal stress, while its radius shows the range of stress variations. At points A and B, where the circle intersects the horizontal axis, the maximum and minimum normal stresses are observed, occurring without shearing stress. These...
710
General State of Stress01:21

General State of Stress

The general state of stress within a material can be accurately depicted using a stress tensor. This tensor encapsulates the internal forces distributed within a material subjected to external forces or deformations.
Specifically, consider a tetrahedral element where one face, labeled XYZ, is perpendicular to the line OA, and the remaining faces align with the coordinate axes with point O as the origin. At any point, such as point O, the stress tensor can be used to determine the stress...
574
Applications of Stress01:04

Applications of Stress

Consider a structure made of a boom and a rod designed to support a load. These two components are connected by a pin and stabilized by brackets and pins. The boom and the rod are detached from their supports to assess the different stresses imposed on this structure, and a free-body diagram is drawn. Then, all the forces applied, including the load acting on the structure, are identified. The reaction forces exerted on both the boom and the rod are computed using the equilibrium equations.
The...
606