Thixo-viscoelastoplastic rheological characterisation of human mucus using a multimode BMP constitutive equation

Michelle Figueroa-Landeta1, Sarahí L Esponda-Cervantes1, M Fernanda Reyes-Tenorio1

  • 1Facultad de Química - Faculty of Chemistry, Departamento de Ingeniería Química - Chemical Engineering Department, Universidad Nacional Autónoma de México - National Autonomous University of Mexico, Ciudad Universitaria, Coyoacán, 04510, CDMX, México.

Scientific Reports
|December 12, 2025
PubMed
Abstract

Related Concept Videos

Members Made of Elastoplastic Material01:19

Members Made of Elastoplastic Material

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...
347
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
497
Types of Fluids01:27

Types of Fluids

Fluids can be classified into Newtonian and non-Newtonian fluids based on their response to shear stress. Newtonian fluids have a linear relationship between shear stress and the shear strain rate, following Newton's law of viscosity. Their viscosity remains constant regardless of the shear rate, making their behavior predictable and easier to analyze. Common examples include water, air, oil, and gasoline.
In contrast, non-Newtonian fluids do not follow Newton's law of viscosity, and...
863
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...
495
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity01:15

Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity

Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.
523