Related Experiment Video

Updated: Aug 5, 2026

Reverse Total Shoulder Arthroplasty
10:10

Reverse Total Shoulder Arthroplasty

Published on: July 5, 2011

43.8K

The effect of adjusting the baseplate size to the glenoid on primary fixation stability in reverse total shoulder

Soung-Yon Kim1, Soo-Won Chae2

  • 1Department of Orthopaedic Surgery, Gyeongsang National University Hospital, College of Medicine, Gyeongsang National University, Jinju, Republic of Korea. soungyon.kim@gmail.com.

Journal of Orthopaedic Surgery and Research
|December 31, 2025
PubMed
Abstract

Keywords:
Adjusting the sizeBaseplateBiomechanical effectGlenoidPrimary fixation stabilityReverse total shoulder arthroplasty

More Related Videos

Three-Dimensional Preoperative Virtual Planning in Derotational Proximal Femoral Osteotomy08:15

Three-Dimensional Preoperative Virtual Planning in Derotational Proximal Femoral Osteotomy

Published on: February 17, 2023

1.4K
Author Spotlight: Development of a Novel Finite Element Analysis Model for Improved Orthognathic Surgical Techniques07:16

Author Spotlight: Development of a Novel Finite Element Analysis Model for Improved Orthognathic Surgical Techniques

Published on: October 20, 2023

1.8K

Related Concept Videos

Reaction Quotient02:35

Reaction Quotient

The status of a reversible reaction is conveniently assessed by evaluating its reaction quotient (Q). For a reversible reaction described by m A + n B ⇌ x C + y D, the reaction quotient is derived directly from the stoichiometry of the balanced equation as
Titration Calculations: Weak Acid - Strong Base03:55

Titration Calculations: Weak Acid - Strong Base

Calculating pH for Titration Solutions: Weak Acid/Strong Base
For the titration of 25.00 mL of 0.100 M CH3CO2H with 0.100 M NaOH, the reaction can be represented as:
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...
Precipitate Formation and Particle Size Control01:16

Precipitate Formation and Particle Size Control

In precipitation gravimetry, the precipitating agent should react specifically or selectively with the analyte. While a specific reagent reacts with the analyte alone, a selective reagent can react with a limited number of chemical species.
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
Reaction Mechanisms: Rate-limiting Step Approximation01:29

Reaction Mechanisms: Rate-limiting Step Approximation

The rate-determining step, or RDS, in a chemical reaction is the slowest step that determines the overall reaction rate. It is identified by using the observed rate law and typically involves approximation methods like the RDS approximation or the steady-state approximation.In the RDS approximation, also known as the rate-limiting-step or equilibrium approximation, the reaction mechanism consists of one or more reversible reactions near equilibrium, followed by a slower RDS, and then one or...