Related Experiment Video

Updated: Jun 9, 2026

Scanning Electron Microscopic Evaluation of Surface Defects of Remover Retreatment File After Single and Multiple Uses
03:07

Scanning Electron Microscopic Evaluation of Surface Defects of Remover Retreatment File After Single and Multiple Uses

Published on: October 11, 2024

885

Comparative finite element analysis of internal root resorption treatment using various root canal filling materials

Büşra Karaağaç Eskibağlar1, Serkan Erdem2, Mehmet Eskibağlar3

  • 1Department of Pediatric Dentistry, Faculty of Dentistry, Firat University, Elazig, Turkey. bkeskibaglar@firat.edu.tr.

BMC Oral Health
|January 4, 2026
PubMed
Abstract

No abstract available in PubMed .

Keywords:
Bioceramic sealerBiodentineFinite element analysisInternal resorptionMineral trioksite aggregate

More Related Videos

Roughness Impact of Piezoelectric Dental Scaler on Two Distinct Flowable Composite Filling Materials05:30

Roughness Impact of Piezoelectric Dental Scaler on Two Distinct Flowable Composite Filling Materials

Published on: January 10, 2025

1.0K
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material07:42

Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material

Published on: December 20, 2024

683

Related Concept Videos

Water and Mineral Acquisition02:34

Water and Mineral Acquisition

Specialized tissues in plant roots have evolved to capture water, minerals, and some ions from the soil. Roots exhibit a variety of branching patterns that facilitate this process. The outermost root cells have specialized structures called root hairs that increase the root surface, thus increasing soil contact. Water can passively cross into roots, as the concentration of water in the soil is higher than that of the root tissue. Minerals, in contrast, are actively transported into root cells.
Bending of Material: Problem Solving01:09

Bending of Material: Problem Solving

In this lesson, determine the ratio of the maximum bending moments applied to two metal pipes, given that both pipes can withstand a maximum stress of 100 MPa. Both pipes have an outer radius of 1.8 cm. Pipe A has an inner radius of 1.5 cm, and Pipe B has an inner radius of 1 cm. The ratio of the maximum bending moment applied to two metallic pipes, each with a different inner and outer radius, is determined by considering their dimensions. The inner radius of the first pipe is 1.5 cm, and for...
Logarithmic Differentiation01:28

Logarithmic Differentiation

When a car’s weight and driving forces act on a tire, they impose an external load on the rubber material. This load is resisted internally by forces distributed throughout the tire structure, which are defined as stress. The resulting deformation of the rubber due to this stress is quantified as strain. The relationship between stress and strain governs how the tire deforms under load and is central to understanding its mechanical response during operation.Rubber exhibits a nonlinear...
Indefinite Integrals01:25

Indefinite Integrals

The water inflow rate into a storage tank is not constant but increases over time. Initially, the pump delivers water at a rate of 5 L/min. However, the inflow rate increases by 2 L/min for each additional minute due to rising pressure or system adjustments. This scenario can be described mathematically by a linear function:It is necessary to integrate the inflow rate function to measure the total volume of water added to the tank over time. The total water volume V(t) is obtained by performing...