Related Concept Videos

Hindsight Biases01:12

Hindsight Biases

Hindsight bias leads you to believe that the event you just experienced was predictable, even though it really wasn’t. In other words, you knew all along that things would turn out the way they did. Can you relate this to the phrase "Hindsight is 20/20" now? 
4.2K
Unusual Results01:16

Unusual Results

Unusual results are those that have a very low chance of occurring. Unusual results can be identified using probabilities and the range rule of thumb. In problems involving probability, unusual results can be observed in 2 instances – an unusually high number of successes or an unusually low number of successes.
According to the range rule of thumb, any value above or below two standard deviations, 2σ  from the mean, μ  is considered unusual.
Maximum unusual value =...
3.7K
Case Studies01:22

Case Studies

There are many research methods available to psychologists in their efforts to understand, describe, and explain behavior and the cognitive and biological processes that underlie it.
13.3K
Torts III01:26

Torts III

Types of Quasi-intentional Torts in Healthcare
Quasi-intentional torts in healthcare involve acts where intent is not directed to harm an individual but results in harm due to careless or reckless speech.
960
Torts II01:13

Torts II

Intentional torts in healthcare refer to deliberate actions that cause harm or infringe on the rights of others. Understanding these torts is crucial for healthcare professionals to avoid legal liabilities and maintain ethical standards in patient care.
864
Angle of Twist: Problem Solving01:13

Angle of Twist: Problem Solving

An electric motor applies a torque of 700 N·m to an aluminum shaft, triggering a stable rotation. Two pulleys, B and C, are subjected to torques of 300 N·m and 400 N·m, respectively. The modulus of rigidity is provided as 25 GPa. With the knowledge of the length and diameter of each segment, the twist angle between the two pulleys can be computed. First, a section cut is made between pulleys B and C, and the cut cross-section is analyzed using a free-body diagram. Given that the torque...
741