Adequacy of Standard Models for Long-Term Behavior of Lightweight Concrete with Sintered Aggregate Under Cyclic...

This paper presents an experimental determination of the long-term mechanical properties of lightweight concrete with sintered aggregate under cyclic loading and the corresponding analytical standard models. The research was designed around two concrete mixtures. Multiple tests were conducted at the Building Structures, Geotechnics and Concrete Laboratory of the Building Research Institute (ITB), using various equipment including creep-testing machines and tensometric measurements of sample deformations. As a result of these tests, in addition to strength properties, the following time-dependent parameters were determined: the secant modulus of elasticity, shrinkage strains, and creep-recovery strains under cyclic loading. For the parameterization and modeling of constitutive equations, an analysis of creep strains under cyclic loads was carried out, taking into account the integral hereditary law according to the Boltzmann superposition principle and the long-term models formulated according to the following standards and pre-standards: Eurocode 2 (2004), Model Code 2010, Model Code 2020, and Eurocode 2 (2023). The results from the individual models were compared with the test results using the rules for evaluating correction factors for models determined according to Eurocode 2 (2023). It was concluded that the development of creep strain is correctly modeled by the aforementioned standard methods, albeit with the aforementioned correction factors. One of the research objectives was to determine whether the ratchetting phenomenon could be observed during creep of the tested concrete under cyclic loading; however, due to the very low level of plastic deformation, this phenomenon was not detected. The research confirmed the suitability of lightweight concrete with sintered aggregate for use in cyclically loaded concrete structures.