Related Experiment Video
Updated: Jan 18, 2026
Four-Dimensional CT Analysis Using Sequential 3D-3D Registration
Published on: November 23, 2019
Analysis of trapeziometacarpal joint congruency during opposition using four dimensional computed tomography
Nathan Bormans1, Manou Acke2, Benyameen Keelson2
1Dept. Orthopaedics and Traumatology, UZ Brussel, Brussels, Belgium.
Objectives:
The trapeziometacarpal (TMC) joint is a puzzling joint with complex kinematics. Historically, instability and subluxation of the TMC joint are quantified by measurements as trapezial tilt, dorsal subluxation angle and radial subluxation ratio on two dimensional radiographs. These measurements are influenced by different factors such as radiographic incidence and position of the thumb relative to the hand. The recent introduction of four dimensional (4D) CT allows analysis of joint kinematics during an in vivo motion. The aim of this study was to analyze the congruency of the TMC joint during an active opposition and retropulsion movement using 4D CT.
Patients And Methods:
A total of 10 healthy volunteers were included and their TMC joint kinematics were studied during a retropulsion-opposition-retropulsion movement. Trapezial tilt, dorsal subluxation angle and radial subluxation ratio were measured for every patient during this active motion.
Results:
Trapezial tilt evolved from 124 in retropulsion to 120 degrees in opposition and evolved from 120 degrees in opposition to 124 degrees in retropulsion. Dorsal subluxation angle evolved from 68 degrees in retropulsion to 45 degrees in opposition and evolved from 44 degrees in opposition to 68 degrees in retropulsion. Radial subluxation ratio evolved from 20% in retropulsion to 20% in opposition and evolved from 19% in opposition to 20% in retropulsion.
Conclusion:
Trapezial tilt and dorsal subluxation decreases with opposition, whereas radial subluxation remains constant. Future research could use this model to investigate the influence of hyperlaxity and osteoarthritis on TMC joint kinematics and joint congruency.
More Related Videos
06:28Anterior Cruciate Ligament Transection and Synovial Fluid Lavage in a Rodent Model to Study Joint Inflammation and Posttraumatic Osteoarthritis
Published on: September 2, 2025
06:31Author Spotlight: Enhancing Rheumatoid Arthritis Research Through HR-pQCT Imaging Analysis
Published on: October 6, 2023
Related Concept Videos
01:10Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
01:09Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...
01:27Imaging Studies III: Computed Tomography
01:30Method of Joints: Problem Solving I
01:30Method of Joints: Problem Solving II
01:29Space Trusses: Problem Solving
Consider a tripod consisting of a tetrahedral space truss with a ball-and-socket joint at C. Suppose the height and lengths of the horizontal and vertical...