Related Experiment Video
Updated: Aug 8, 2026

Characterization of Recombination Effects in a Liquid Ionization Chamber Used for the Dosimetry of a Radiosurgical Accelerator
Published on: May 9, 2014
Influence of air cavities on central depth dose curves for 33 MV roentgen rays
Abstract:
The relative central absorbed dose preceding and following air layers and channels in a polytetrafluorethylene (teflon) phantom has been measured with LiF-teflon dosimeters. Focus phantom distance is set to 100 cm and the field sizes range from 3 cm X 3 cm to 6 cm X 6 cm. Absorbed dose decrease and build-up factors in front of and behind the air cavity are evaluated. The build-up factor is strongly dependent on field size. Measurements of absorbed dose in water and polystyrene yield approximately the same results as in teflon if the linear dimensions of the irradiation geometry (including depth in phantom) in water and polystyrene are equal to 1.84 and 1.99 respectively times the corresponding parameter in teflon. The underlying transformation procedure is derived. The absorbed dose correction factors in the region behind the slab are discussed in terms of tissue-air-ratio and effective attenuation formulae.
Related Concept Videos
Biological Effects of Radiation
X-ray Imaging
Pressure Relationships in Thoracic Cavity
Breathing Mechanisms
Both intra-alveolar and intrapleural pressures rely on specific lung properties. The ability to breathe—allowing air to enter the lungs during...
Factors Affecting Pulmonary Ventilation
Alveolar Surface Tension
The alveolar fluid lines the luminal surface of the alveoli and exerts a force called surface tension. This force is caused by the polar water molecules in the liquid being more strongly attracted to each...
External and Internal Respiration
Influence of Earth's Curvature and Atmospheric Refraction on Leveling

