Related Experiment Video
Updated: Jan 21, 2026

Detection of Aggregation-Prone Behavior in Mutant P53 V157F Breast Cancer Cells Using Multipoint Thioflavin T Fluorescence
Published on: December 30, 2025
Detection of Aggregation-Prone Behavior in Mutant P53 V157F Breast Cancer Cells Using Multipoint Thioflavin T
Shao-I Chin1, Zi-Min Zeng2, Sih-Tong Chen3
1School of Medicine, I-Shou University.
Abstract:
The tumor suppressor p53, encoded by the TP53 gene, plays a central role in maintaining genomic stability. TP53 mutations, particularly hotspot variants, are found in approximately 50% of human cancers and may lead to the loss of tumor-suppressive functions or the acquisition of gain-of-function properties, including aggregation into prion-like structures. In this study, we assessed the aggregation tendency of the p53 V157F mutation in Hs578T breast cancer cells compared to MCF7 cells expressing wild-type p53. Protein aggregation was evaluated using Thioflavin T (ThT) staining followed by fluorescence quantification in 96-well plate assays. Cells were stained with a ThT/Hoechst solution, washed, and analyzed using a microplate reader under defined excitation/emission parameters. Quantitative analysis using both single-point and four-point fluorescence readings revealed that Hs578T cells exhibited a 3.20- to 4.26-fold increase in ThT fluorescence intensity relative to MCF7, indicating significantly elevated levels of β-sheet-rich or amyloid-like aggregates. Multipoint measurements confirmed the widespread and consistent presence of protein aggregates across the well surface. These findings support the use of multipoint plate-reading to accurately detect protein aggregation in cell-based assays.
Related Concept Videos
What is Behavior?
Aggregates Classification
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
Bonding and Strength of Aggregate
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Bulk Density of Aggregate
Most natural mineral aggregates, like sand and gravel,...
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...

