When analyzing a single line-to-ground fault from phase A to ground at a three-phase bus, it is important to consider the fault impedance. This impedance is zero for a bolted fault, equal to the arc impedance for an arcing fault, and represents the total fault impedance for a transmission-line insulator flashover. To derive sequence and phase currents, fault conditions are translated from the phase domain to the sequence domain.
For line-to-line faults occurring between phases B and C, the...

An ogive graph is sometimes called a cumulative frequency polygon. It is one type of frequency polygon that shows cumulative frequency. In other words, the cumulative percentages are added to the graph from left to right. An ogive graph plots cumulative frequency on the vertical y-axis and class boundaries along the horizontal x-axis. It’s very similar to a histogram; only instead of rectangles, an ogive displays a single point where the top right of the rectangle would be. Creating this...

The concept of an antiderivative is fundamental in calculus, describing how a function's values accumulate over time. This process is closely related to physical motion, such as the movement of a rolling ball. As the ball progresses, its position changes in response to variations in velocity, just as an antiderivative graph reflects the cumulative effect of the original function's values.Graphing an antiderivative requires interpreting how a function's values influence the shape of its...

A bar graph is also called a bar chart and consists of bars that are separated from each other. It either uses horizontal or vertical bars to show comparisons among categories. The bars can be rectangles, or they can be rectangular boxes (used in three-dimensional plots). One axis of the graph represents the specific categories being compared, and the other axis shows a discrete value. In this graph, the length of the bar for each category is proportional to the number or percent of individuals...

A time-series graph is a line graph with repeated measurements taken at successive intervals of time. It is also called a time series chart. To construct a time-series graph, one must look at both pieces of a paired data set. The horizontal axis is used to plot the time increments, and the vertical axis is used to plot the values of the variable that one is measuring. By using the axes in this way, each point on the graph will correspond to time and a measured quantity. The points on the graph...

As the name suggests, a multiple bar graph is the same as a bar graph but has multiple bars to depict relationships between different data values. One can include as many parameters as possible. However, each parameter must have the same unit of measurement.
Each bar or column in the multiple bar graph represents a data value. These graphs are used primarily in interrelating two or more sets of data. The categories of different kinds of data are listed along the horizontal or x-axis, whereas...