Related Experiment Video
Updated: Jan 25, 2026

Autologous Microfractured and Purified Adipose Tissue for Arthroscopic Management of Osteochondral Lesions of the Talus
Published on: January 23, 2018
In silico assessment of talus osteochondral lesion size and location on biomechanical load distribution using tilted
Lercan Aslan1, Omer Subasi2, Bedri Karaismailoglu2
1Department of Orthopaedics and Traumatology, Koç University School of Medicine, İstanbul, Türkiye.
Objective:
This study aimed to computationally evaluate the effects of lesions of varying sizes and locations on stress distribution and ankle stiffness across the nine-zone grid of the talar dome in three different ankle positions.
Methods:
An adult ankle geometry was modeled with 1 mm of cartilage on both sides of the tibiotalar contact. Lesions with diameters of 4.5, 6.4, and 9 mm were created on the talar dome at each grid partition, ranging from section 1 (anteromedial) to 9 (posterolateral). The key innovation of the study was the use of tilted talar planes to account for the dome's curvature, enabling more accurate lesion model ing and biomechanical analysis. Percent changes in osteochondral von Mises stress distribution and ankle stiffness parameters were investigated using finite element analysis. Based on the designated design parameters, 81 different cases were modeled and simulated.
Results:
Zones 7 (posteromedial, -33.2% change in stiffness for a 9 mm defect), 3 (anterolateral, -24.2% change in stiffness for a 9 mm defect), and 8 (mid-posterior, -48.8% change in stiffness for a 9 mm defect) were found to be the most critical zones, showing evidence of decreased ankle stiffness in neutral, dorsiflexion, and plantarflexion positions, respectively. Zone 9 (posterolateral; neutral -4.7%, dorsi flexion 5.4%, plantarflexion 0.17% stiffness change for a 9 mm defect) was found to be the least critical zone in terms of biomechanical stiffness.
Conclusion:
From a clinical standpoint, since lesions in zones 8, 7, and 3 significantly impact joint biomechanics compared to other zones, more aggressive cartilage restoration or augmentation could be required while lesions in less problematic zones like zone 9 can be treated withmicrofracture surgery. Cite this article as: Aslan L, Subasi O, Karaismailoglu B, et al. In silico assessment of talus osteochondral lesion size and location on biomechanical load distribution using tilted talar dome planes. Acta Orthop Traumatol Turc., 2025;59(6):361-367.
More Related Videos
Related Concept Videos
Distributed Loads
For example, consider a bookshelf filled with books stacked vertically adjacent to each other. The weight of the books is evenly distributed over the length of the shelf. As a result, the pressure at different locations on the surface of the...
Eccentric Axial Loading in a Plane of Symmetry
Distributed Loads: Problem Solving
Resultant of a General Distributed Loading
Examples such as load distribution due to wind and load distribution on a bridge illustrate how this concept is used to analyze and design safe, reliable structures under variable loading conditions. Most structures, such as residential buildings, bridges, and towers, are...
Pore Size Distribution
Adequate...
Cable Subjected to a Distributed Load

