Related Experiment Video

Updated: Jan 28, 2026

Iridium Oxide-reduced Graphene Oxide Nanohybrid Thin Film Modified Screen-printed Electrodes as Disposable Electrochemical Paper Microfluidic pH Sensors
09:15

Iridium Oxide-reduced Graphene Oxide Nanohybrid Thin Film Modified Screen-printed Electrodes as Disposable Electrochemical Paper Microfluidic pH Sensors

Published on: November 22, 2016

11.0K

Designing in situ nanostructured MWCNT-phloroglucinol modified webs for electrochemical-based dual screening of

Mansi Gandhi1, Anitha Varghese1

  • 1Department of Chemistry, CHRIST (Deemed to be University), Hosur Road, Bengaluru-560029, India. anitha.varghese@christuniversity.in.

Physical Chemistry Chemical Physics : PCCP
|January 27, 2026
PubMed

More Related Videos

Biomarkers in an Animal Model for Revealing Neural, Hematologic, and Behavioral Correlates of PTSD08:29

Biomarkers in an Animal Model for Revealing Neural, Hematologic, and Behavioral Correlates of PTSD

Published on: October 10, 2012

16.7K
Screening of Coatings for an All-Solid-State Battery Using In Situ Transmission Electron Microscopy07:20

Screening of Coatings for an All-Solid-State Battery Using In Situ Transmission Electron Microscopy

Published on: January 20, 2023

3.3K

Related Concept Videos

What is an Electrochemical Gradient?01:26

What is an Electrochemical Gradient?

Adenosine triphosphate, or ATP, is considered the primary energy source in cells. However, energy can also be stored in the electrochemical gradient of an ion across the plasma membrane, which is determined by two factors: its chemical and electrical gradients.
The chemical gradient relies on differences in the abundance of a substance on the outside versus the inside of a cell and flows from areas of high to low ion concentration. In contrast, the electrical gradient revolves around an...
127.6K
Design of Transmission Shafts - Stress Analysis01:15

Design of Transmission Shafts - Stress Analysis

Designing a transmission shaft requires a thorough understanding of the stresses induced by bending moments and torques, especially in systems where power is transferred through gears. These forces create force-couple systems at the centers of the shaft's cross-sections, leading to both transverse and torsional loading. Although shearing stresses from transverse loads are typically smaller than those from torques and are often overlooked, the significant normal stresses from these loads...
738
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.4K
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.8K
Responses to Salt Stress02:02

Responses to Salt Stress

Salt stress—which can be triggered by high salt concentrations in a plant’s environment—can significantly affect plant growth and crop production by influencing photosynthesis and the absorption of water and nutrients.
14.5K
Interfacial Electrochemical Methods: Overview01:06

Interfacial Electrochemical Methods: Overview

Interfacial electrochemical methods focus on the phenomena occurring at the boundary between an electrode and a solution, as opposed to bulk methods that concentrate on the solution's overall properties. These interfacial methods are classified as either static or dynamic based on the presence of a nonzero current in the electrochemical cell and the consistency of analyte concentrations. Static methods, such as potentiometry, measure the cell's potential without any significant current...
859