Dynamic arthroscopy in retropatellar cartilage defect: identifying trochlear ridge impingement and guiding towards

Niels Merkelbach1, Hidde D Veldman2,3, Maarten Pf Janssen1

  • 1Department of Orthopaedic Surgery, MUMC+, Maastricht, The Netherlands.

BMJ Case Reports
|January 29, 2026
PubMed

Related Concept Videos

Lumber Defects01:23

Lumber Defects

Lumber defects, which can affect both the appearance and structural integrity of wood, include a variety of growth and manufacturing flaws. Growth defects such as knots and knotholes occur where branches were once attached to the tree trunk, with knotholes forming when these knots fall out. Other natural defects include decay and insect damage, which compromise the wood's strength and durability.
Shakes are minor fractures that run along or across the wood's annual rings, while wane is...
516
Growth of Cartilage and Bone Tissue01:27

Growth of Cartilage and Bone Tissue

Chondrocytes form a temporary cartilaginous model by dividing and secreting a thick gel-like extracellular matrix. Once the chondrocytes undergo programmed cell death, osteoblasts enter the site of the cartilaginous model. The process of replacing the temporary cartilaginous model with bone in an ordered manner is called endochondral ossification. In endochondral ossification, not all of the cartilage is replaced by bone tissue. Some cartilage that performs a protective and supportive function...
4.2K
Dynamic Equilibrium02:20

Dynamic Equilibrium

A reversible chemical reaction represents a chemical process that proceeds in both forward (left to right) and reverse (right to left) directions. When the rates of the forward and reverse reactions are equal, the concentrations of the reactant and product species remain constant over time and the system is at equilibrium. A special double arrow is used to emphasize the reversible nature of the reaction. The relative concentrations of reactants and products in equilibrium systems vary greatly;...
62.6K
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
3.8K
Equation of Rotational Dynamics01:08

Equation of Rotational Dynamics

Angular variables are introduced in rotational dynamics. Comparing the definitions of angular variables with the definitions of linear kinematic variables, it is seen that there is a mapping of the linear variables to the rotational ones. Linear displacement, velocity, and acceleration have their equivalents in rotational motion, which are angular displacement, angular velocity, and angular acceleration. Similar to the rotational variables, a mapping exists from Newton's second law of motion...
14.8K
Dynamics of Circular Motion01:30

Dynamics of Circular Motion

An object undergoing circular motion, like a race car, is accelerating because it is changing the direction of its velocity. This centrally directed acceleration is called centripetal acceleration. This acceleration acts along the radius of the curved path (thus is also referred to as radial acceleration).
Any acceleration must be produced by some force. Therefore, any force or combination of forces can cause centripetal acceleration. A few examples include the tension in the rope on a...
25.4K