Related Experiment Video
Updated: Feb 1, 2026

Four-Dimensional CT Analysis Using Sequential 3D-3D Registration
Published on: November 23, 2019
Tibial Slope Variation Across Coronal Plane Alignment of the Knee Phenotypes: A Three-Dimensional Computed
Vicente Jesús León-Muñoz1,2,3,4, José Hurtado-Avilés5, Pablo Sanchez-Urgelles6
1Department of Orthopaedic Surgery and Traumatology, Hospital General Universitario Reina Sofía, Murcia, Spain.
Abstract:
The Coronal Plane Alignment of the Knee (CPAK) classification system categorizes nine phenotypes based on constitutional limb alignment and joint line obliquity (JLO). Understanding relationships between CPAK phenotypes and tibial slope (TS) could streamline total knee arthroplasty planning. This study investigated the correlations between CPAK classification and medial TS in patients with osteoarthritis. A retrospective analysis of 622 cases in 535 patients with osteoarthritis undergoing primary total knee arthroplasty was conducted. Three-dimensional computed tomography imaging with MyPlanner software determined mechanical lateral distal femoral angle, mechanical medial proximal tibial angle, and medial TS. Statistical analysis included multiple linear regression, Pearson correlation, and one-way analysis of variance (ANOVA) with Tukey post hoc testing. Outliers were removed using interquartile range criteria, resulting in 581 knees for final analysis. Multiple linear regression revealed minimal correlation between coronal alignment and TS (TS = 26.35 - 0.1045 arithmetic hip-knee-ankle [aHKA] - 0.1004 JLO; r 2 = 0.0233). aHKA angle and JLO explained only 2.33% of TS variance. Contour mapping demonstrated no discernible patterns in data distribution. Despite weak correlations, ANOVA identified statistically significant differences between CPAK groups for TS (F = 2.97; p = 0.003). Tukey post hoc analysis revealed significant differences between CPAK group I and groups V and VII, with mean differences ranging 1.39 to 2.06 degrees. No clinically meaningful relationship exists between CPAK classification and TS in osteoarthritic knees. While statistical significance differences were observed between certain CPAK groups, the extremely low correlation coefficient and small effect sizes indicate these differences fall within measurement variability and are substantially smaller than TS variations that influence total knee arthroplasty outcomes. CPAK classification cannot reliably predict sagittal plane morphology, necessitating an independent, comprehensive three-dimensional assessment of coronal and sagittal characteristics during surgical planning.Level III-Retrospective Comparative Study.
Related Concept Videos
What is Variation?
The range, standard deviation, standard error, and variance are the different measures of variation.
Range: The range is the difference between its maximum and...
Variation
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
Knee Joint
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris...
Conservative Site-specific Recombination and Phase Variation
The recognition sites for Cre recombinase called LoxP...
Variation: Normal Distribution, Range, and Standard Deviation
Variation of Atmospheric Pressure
Assuming the air temperature is constant at a given altitude and that the ideal gas law of thermodynamics describes the atmosphere to a good approximation, one can find the variation of atmospheric pressure with height.
Let p(y) be the atmospheric pressure at...

