GC-FID quantification of methanol, ethanol, 2-propanol, acetone, ethylene glycol, diethylene glycol, 1,2-propylene glycol and 1,3-propylene glycol in plasma
Related Experiment Video
Updated: May 5, 2026

Microdialysis of Ethanol During Operant Ethanol Self-administration and Ethanol Determination by Gas Chromatography
Published on: September 5, 2012
Mohsin El Amrani1, Arjan Zandbergen1, Mike Groot1
1Department of Clinical Pharmacy, Division Laboratories, Pharmacy and Biomedical Genetics, University Medical Center Utrecht, Utrecht University, Utrecht, 3508 GA, The Netherlands.
Abstract:
Alcohol and glycol ingestion, including substances such as methanol, ethylene glycol, and isopropanol, constitute a serious medical emergency that requires prompt diagnosis and treatment of patients. Rapid and accurate quantification of these compounds in plasma is essential to guide clinical decision-making and prevent delays in treatment that could result in irreversible organ damage or death. Many healthcare facilities lack analytical methods capable of simultaneously quantifying both alcohols and glycols in a single run. This study describes the development and validation of a rapid gas chromatography-flame ionization detection (GC-FID) method for the simultaneous screening and quantification of methanol, ethanol, 2-propanol, acetone, ethylene glycol, diethylene glycol, 1,2-propylene glycol, and 1,3-propylene glycol in human plasma. Plasma samples were prepared using a protein precipitation technique with acetonitrile containing two internal standards: 2-butanol and 1,4-butanediol. Acetonitrile effectively precipitated plasma proteins. The supernatant was then subjected to GC-FID analysis for quantification of the target al.ohols and glycols. The total analytical run time was 5 minutes, enabling the quantification of eight analytes in a single injection. The method demonstrated excellent linearity, with correlation coefficients (R2) exceeding 0.9995 for all compounds. The linear dynamic range was 40-1280 mg/L for methanol, 2-propanol, acetone, ethylene glycol, diethylene glycol, 1,2-propylene glycol, and 1,3-propylene glycol, and 80-2560 mg/L for ethanol. Within-run and between-run precision and accuracy (CV and bias) for all analytes were within the predefined acceptance criteria of ±15%. No significant interference, carry-over, or matrix effects were observed, confirming the method's selectivity and robustness. The developed GC-FID method enables rapid, accurate, and simultaneous quantification of toxic alcohols and glycols in plasma within a 5-minute run time. The excellent linearity, precision, and selectivity of the method met al. analytical performance criteria, making it well-suited for routine clinical use. This method provides a valuable tool for timely diagnosis and management of suspected toxic alcohol and glycol ingestions in patients in emergency settings.
More Related Videos
Related Concept Videos
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are...
Structure and Nomenclature of Alcohols and Phenols
Alcohols are one of the most important functional groups in organic chemistry. The name of alcohol comes from the hydrocarbon from which it is derived. Alcohols are organic molecules containing the functional hydroxyl or –OH group directly bonded to carbon. Phenols have an OH group directly attached to a benzene ring. While alcohols are colorless, phenol is a white crystalline compound with a characteristic "hospital smell" odor.
As with other organic compounds, alcohols and...

