Portable Point-of-Care Uric Acid Detection System with Cloud-Based Data Analysis and Patient Monitoring

Uric acid is closely related to diseases such as gout, kidney failure, and metabolic disorders. A conventional method for measuring uric acid over 24 h is time intensive and cumbersome for patients who have to take samples to the hospital. At present, hospitals use only laboratory instruments to determine 24-h uric acid concentrations in the urine. This study presents the proof-of-concept of a portable point-of-care tool called Uricia, designed to improve the quality of life of patients monitoring uric acid. Spectrophotometry was performed at a fixed wavelength of 295 nm. The urine sample contained within the cuvette absorbs ultraviolet light, with uric acid specifically responsible for this absorption, thereby allowing the device to measure its concentration. An internal calibration algorithm was used to accommodate the nonlinear optical response of Uricia and was calibrated to a benchtop GENESYS 10S UV-Vis spectrophotometer. The experiments further evaluated potential urinary interferences, revealing that while most constituents had minimal impact, ascorbic acid demonstrated the highest interference, contributing up to 15% of the total signal at high physiological concentrations. This device and the corresponding spectrophotometry method revealed that high concentrations of uric acid precipitated insoluble crystals. A dilution set to an alkali solution vial to be premixed and dissolve the uric acid crystals was added, increasing the detection window to 10 mg/dL, with an LOD of 0.0232 mg/dL and LOQ of 0.0702 mg/dL. Cloud-based data measurement enables spot analysis, which is meant to provide insight into patient status development. These results validated the technical architecture of a controlled matrix for measuring uric acid.