Optimization Study on the Two-Color Injection Molding Process of Medical Protective Goggles Based on the BP-SSA...

To solve common defects such as warpage deformation, interface debonding, and uneven filling during the two-color injection molding of medical goggles while meeting their multi-performance requirements, including high light transmittance, impact resistance, chemical corrosion resistance, and structural stability, this study conducts research on the process optimization of two-color injection molding. Firstly, based on the principle of material compatibility and Moldflow simulation, a suitable material combination was selected: the first-shot frame adopts Apec 1745 PC material, and the second-shot lens uses Makrolon 2858 PC material, which effectively avoids the risk of interface non-fusion. Subsequently, a high-precision 3D simulation model was established using Moldflow software, and the injection sequence of "frame first, lens second" was optimized and determined. A gating system with double-gate (for the frame) and single-gate side feeding (for the lens), as well as a cooling system with an 8 mm diameter, was designed, and all key indicators of mesh quality meet the simulation requirements. Taking the mold and melt temperatures, holding pressures, and holding times of the two shots as design variables and warpage deformation as the optimization objective, sample data were obtained through an L₃₂ (7⁴) orthogonal test. A BP neural network was constructed to describe the nonlinear relationship between parameters and quality, and the Sparrow Search Algorithm (SSA) was combined to optimize the weights and thresholds of the network, forming a BP-SSA intelligent optimization model. The results show that the mean absolute percentage error (MAPE) of the proposed model is only 2.28%, which is significantly better than that of the single BP neural network (14.36%). The optimal process parameters obtained by optimization are a mold temperature of 130 °C, first-shot melt temperature of 311 °C, second-shot melt temperature of 310 °C, first-shot holding pressure of 83 MPa, second-shot holding pressure of 70 MPa, first-shot holding time of 14 s, and second-shot holding time of 8 s. Simulation and mold test verification indicate that after optimization, the warpage deformation of the goggles is reduced to 0.8956 mm (simulation) and 0.944 mm (measured), with a relative error of only 5.4%, which is 67.9% lower than the initial simulation result. The integrated method of "material selection-CAE simulation-orthogonal test-BP-SSA intelligent optimization" proposed in this study provides technical support for the high-precision manufacturing of thin-walled transparent multi-material medical products.