Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Solid–Solid Solutions01:24

Solid–Solid Solutions

67
The temperature-composition phase diagram of two solids, A and B, which are immiscible in the solid phase but form miscible liquids, shows that when the temperature is low, these two exist as separate, pure solids (A and B). As the temperature increases, they transition into a single-phase liquid solution where A and B coexist. Moving from point a1 to a2 in the phase diagram, the composition changes such that solid B begins to separate from the solution, enriching the remaining liquid with A.
67
Recrystallization: Solid–Solution Equilibria01:10

Recrystallization: Solid–Solution Equilibria

4.7K
Recrystallization is a purification technique used to separate impurities from solid compounds. In this technique, no chemical reactions occur. Instead, it exploits physical properties only, specifically, the solubility differences between the desired compound and impurities, either at a single temperature or at different temperatures, and under other selected conditions. The solid-solution equilibrium (solubility equilibrium) of each component in the solution represents a binary phase...
4.7K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

15.6K
Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
15.6K
Phase Diagrams of Ternary Systems01:28

Phase Diagrams of Ternary Systems

52
Consider a ternary system, which is composed of three components: water (W), ethanoic acid (E), and trichloromethane (T). Here, Ethanoic acid (E) is fully miscible with both water (W) and trichloromethane (T), meaning it can mix entirely with either of them. However, water and trichloromethane have partial miscibility, meaning they can only mix to a certain extent, beyond which two separate phases will form.The phase diagram of a ternary system is represented as an equilateral triangle, where...
52
Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility02:34

Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility

53.4K
Intermolecular forces are attractive forces that exist between molecules. They dictate several bulk properties, such as melting points, boiling points, and solubilities (miscibilities) of substances. Molar mass, molecular shape, and polarity affect the strength of different intermolecular forces, which influence the magnitude of physical properties across a family of molecules.
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
53.4K
The Fluid Mosaic Model01:34

The Fluid Mosaic Model

184.1K
The fluid mosaic model was first proposed as a visual representation of research observations. The model comprises the composition and dynamics of membranes and serves as a foundation for future membrane-related studies. The model depicts the structure of the plasma membrane with a variety of components, which include phospholipids, proteins, and carbohydrates. These integral molecules are loosely bound, defining the cell’s border and providing fluidity for optimal function.
184.1K

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Self-assembly: From blueprints to breakthroughs.

The Journal of chemical physics·2026
Same author

Vacancy defects in square-triangle tilings and their implications for quasicrystals formed by square-shoulder particles.

The Journal of chemical physics·2026
Same author

Narrowing down the cause of the hard-sphere nucleation discrepancy: The free energy of precritical nuclei is consistent with predictions.

Science advances·2026
Same author

Self-assembly of quasicrystals under cyclic shear.

Soft matter·2026
Same author

Solid-angle based nearest-neighbor algorithm adapted for systems with low coordination number.

The Journal of chemical physics·2026
Same author

Quantitative 3D Real-Space Analysis of Photonic Supraparticles.

Advanced materials (Deerfield Beach, Fla.)·2026

Related Experiment Video

Updated: Mar 24, 2026

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers
12:37

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers

Published on: September 4, 2015

13.1K

Determining fluid-crystal phase boundaries for a binary hard-sphere mixture using direct-coexistence simulations.

Rinske M Alkemade1, Alessandro Salo1, Laura Filion1

  • 1Soft Condensed Matter and Biophysics, Debye Institute for Nanomaterials Science, Utrecht University, Utrecht, Netherlands.

The Journal of Chemical Physics
|March 23, 2026
PubMed
Summary

A new method accurately determines fluid-crystal phase boundaries in binary mixtures by extending a strain-free direct-coexistence approach. This robust technique simplifies phase boundary determination without needing prior equation of state knowledge.

More Related Videos

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses
08:55

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses

Published on: June 7, 2018

9.0K
Phase Behavior of Charged Vesicles Under Symmetric and Asymmetric Solution Conditions Monitored with Fluorescence Microscopy
10:08

Phase Behavior of Charged Vesicles Under Symmetric and Asymmetric Solution Conditions Monitored with Fluorescence Microscopy

Published on: October 24, 2017

9.7K

Related Experiment Videos

Last Updated: Mar 24, 2026

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers
12:37

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers

Published on: September 4, 2015

13.1K
Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses
08:55

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses

Published on: June 7, 2018

9.0K
Phase Behavior of Charged Vesicles Under Symmetric and Asymmetric Solution Conditions Monitored with Fluorescence Microscopy
10:08

Phase Behavior of Charged Vesicles Under Symmetric and Asymmetric Solution Conditions Monitored with Fluorescence Microscopy

Published on: October 24, 2017

9.7K

Area of Science:

  • Materials Science
  • Chemical Engineering
  • Computational Chemistry

Background:

  • Direct-coexistence simulations for fluid-crystal phase boundaries are often complicated by crystal strain.
  • A recent direct-coexistence method simplifies identifying equilibrium strain-free fluid-crystal coexistence in monodisperse systems.

Purpose of the Study:

  • To extend the strain-free direct-coexistence method to binary mixtures forming stoichiometric binary crystals.
  • To accurately and efficiently determine fluid-crystal phase boundaries in these systems.
  • To investigate the influence of crystal plane selection on phase boundary accuracy.

Main Methods:

  • Adaptation of a direct-coexistence approach for binary mixtures.
  • Simulation of stoichiometric binary crystals in contact with their fluid phase.
  • Analysis of the impact of different crystal planes on phase boundary determination.

Main Results:

  • The direct-coexistence method was successfully extended to binary mixtures forming stoichiometric binary crystals.
  • Accurate and efficient determination of fluid-crystal phase boundaries was achieved.
  • The choice of crystal plane was shown to affect the accuracy of phase boundary determination.

Conclusions:

  • The extended direct-coexistence method provides a robust and practical tool for determining fluid-crystal phase boundaries in binary mixtures.
  • The method is easy to implement and does not require prior knowledge of the binary fluid's equation of state.
  • This work establishes a reliable approach for understanding phase behavior in complex fluid systems.