Simulation of Static Ultrasonic Welding Based on Explicit Simulation and a More Accurate Representation of the...

The utilisation of composite materials has the potential to play a vital role in the development of lightweight structures for future generations of aircraft, with the objective to reduce emissions. Ultrasonic welding is a process that has been proven to exhibit advantageous qualities, including the capacity to achieve welds with a comparatively short process time. Furthermore, its capacity to function as both a static and a continuous process makes it a viable candidate for facilitating the realisation of this objective. The present study investigates the potential of a novel explicit modelling approach for the static ultrasonic welding process to more accurately represent the welding process by incorporating a more precise representation of the hammering effect. The hammering effect describes the partial loss of contact between the sonotrode and the upper adherend. The model's validation was achieved through a multifaceted approach that incorporates high-speed camera recording, encompassing digital image correlation, laser displacement sensor measurements, and static ultrasonic welding experiments. These experiments encompassed varying welding times, followed by fracture surface analysis. The findings showed that an explicit time-domain model can effectively represent the static welding process of unidirectional materials utilising a film energy director. The experimental validation demonstrated a high degree of correlation between the thermal behaviour of the welding interface and the simulation results. The study demonstrated that the neutral position of the sonotrode exhibited an increase during the initial phase of the welding process due to dynamic stresses. This phenomenon enables reduced constraint movement of the adherends and the energy director, which results in the disconnection of the sonotrode from both the upper adherend and the energy director, as well as the adherends and the anvil. The higher neutral position of the sonotrode was then implemented in an explicit simulation of the static ultrasonic welding process.