Related Experiment Video
Updated: Mar 31, 2026

Physical, Chemical and Biological Characterization of Six Biochars Produced for the Remediation of Contaminated Sites
Published on: November 28, 2014
Enhancement of Petroleum Hydrocarbon Adsorption Performance by Attapulgite Modified Biochar: Performance and
Yuanyuan Shao1,2,3, Wenyang Wang4, Na Liu5,6
1Northwest Institute of Eco-Environment and Resources, Chinese Academy of Sciences, Lanzhou 730000, China.
None:
Two biochar-based adsorbents, namely, original corn cob biochar and attapulgite-biochar composite, were prepared via two-step pyrolysis at 400 and 700 °C under oxygen deficiency for petroleum hydrocarbon removal from water. Experimental results revealed that attapulgite modified the structure of biochar, increased the quantity of surface functional groups, and thereby significantly enhanced its adsorption capacity. Petroleum hydrocarbon adsorption experiments showed that adsorption kinetics was more accurately characterized by the pseudo-second-order model and isothermal adsorption was characterized by the Freundlich model, supported by R 2 and error analysis. This finding suggested that chemisorption through multimolecular layers was the predominant mechanism of adsorption. Regarding the effect of pH, the original biochar exhibited maximum adsorption capacity under weakly acidic conditions (pH 5.0), while the attapulgite-biochar composite achieved optimal adsorption performance in neutral to weakly alkaline environments (pH = 7.0-9.0), and attapulgite-biochar composite exhibited an adsorption rate 41.8% higher than that of the original biochar. In terms of salinity, it exerted a notable influence on the adsorption capacity of biochar; however, the attapulgite-biochar composite demonstrated superior adaptability over a wider salinity range (0.5% to 8.0%) and a 65.14% increase in overall adsorption efficiency compared to the original biochar. Gas chromatography-mass spectrometry and Fourier transform infrared spectroscopy indicated that the adsorption mechanism primarily encompassed surface adsorption, interfacial adsorption, micropore filling, hydrogen bonding, π-π bond interactions, and chelation effects. Additionally, specific redox reactions might have occurred alongside the adsorption process. In conclusion, this low-cost, environmentally friendly, and highly efficient carbon material holds considerable promise for the removal of oil pollutants in saline-alkali environments.
More Related Videos
11:28Biomass Conversion to Produce Hydrocarbon Liquid Fuel Via Hot-vapor Filtered Fast Pyrolysis and Catalytic Hydrotreating
Published on: December 25, 2016
10:44Preparation of Biomass-based Mesoporous Carbon with Higher Nitrogen-/Oxygen-chelating Adsorption for CuII Through Microwave Pre-Pyrolysis
Published on: February 12, 2019
Related Concept Videos
Microbial Bioremediation of Hydrocarbons
Adsorption Isotherms II
Adsorption of Gases on Solids
Bioremediation
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...