Vertical-horizontal rotation of EVO-ICL to correct suboptimal vault based on vertically oval sulcus anatomy

Hannuy Choi1, Ik Hee Ryu1, In Sik Lee1

  • 1Department of refractive surgery, B&VIIT Eye Center, Seoul, South Korea.

Related Concept Videos

Cranial Bones: Lateral View01:27

Cranial Bones: Lateral View

The lateral view of the cranium is dominated by temporal, sphenoid, and ethmoid bones.
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
7.9K
Cranial Bones: Superior and Posterior View01:14

Cranial Bones: Superior and Posterior View

The superior view of the cranium shows the frontal and paired parietal bones.
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...
8.7K
Rotation of Asymmetric Top01:11

Rotation of Asymmetric Top

By definition, a spherically symmetric body has the same moment of inertia about any axis passing through its center of mass. This situation changes if there is no spherical symmetry. Since most rigid bodies are not spherically symmetric, these require special treatment.
The relationship between the angular momentum of any rigid body and its angular velocity, both of which are vectors, involves the moment of inertia. The moment of inertia is a scalar quantity only for spherically symmetric...
1.8K
Deformations in a Transverse Cross Section01:21

Deformations in a Transverse Cross Section

When a material is subjected to uniaxial stress, it elongates or contracts in the direction of the applied force, and also undergoes changes in the perpendicular directions. This behavior is crucial for understanding how materials behave under stress and is governed by mechanical properties such as Poisson's ratio v, which measures the ratio of transverse strain to axial strain.
As the material stretches, it expands or contracts in orthogonal directions to the load. This phenomenon varies...
730
Elevation of Intermediate Points on Vertical Curves01:20

Elevation of Intermediate Points on Vertical Curves

Vertical curves are essential in roadway design because they provide smooth transitions between varying roadway grades. Designing vertical curves involves calculating intermediate elevations and identifying the curve's highest or lowest point, which is essential for optimal roadway performance.Intermediate elevations on a vertical curve are determined using the tangent offset method. This method considers the initial elevation at the start of the curve, the grades, and the curve's geometry. The...
339
Anatomy of the Brain: Ventricles01:18

Anatomy of the Brain: Ventricles

There are hollow fluid-filled cavities known as ventricles deep inside the human brain. There are two lateral ventricles, one in each cerebral hemisphere, and each has three different projections — the anterior, inferior, and posterior horns visible from the lateral side. A thin membrane called the septum pellucidum separates the two lateral ventricles. The slender third ventricle in the diencephalon is connected to each lateral ventricle via a channel called the interventricular foramen.
11.2K